Want this question answered?
It depends upon the wattage of the light bulb. The lower the bulb wattage the lower the heat generated by the bulb. A 100 watt bulb should generate enough heat to destroy a rubber band.
The bulb glows because the filament inside ( made of tungsten) get's so hot that it becomes red and starts emitting light. A little of it's heat is also radiated to the glass of the bulb and that's what makes it hot. But it will never get hot enough to melt a rubber band.
The horn is underneath the front right light bulb remove the light bulb and its underneath a rubber like sheet.
Open the hood, get to the back of the light, remove the rubber cover and the light is visible. Turn the light bulb housing and pull the bulb out. Installing is the reverse.
Remove rubber boot. Pull off plug. Twist light bulb 1/4 turn and bulb should come out.
no
Eight people are more than enough to change a light bulb. Usually one person is needed.
light bulb toilet rubber penny pound
Only two, as long as the light bulb has a hole, large enough for them to enter!
Yes, a light bulb is a source of light. When current is going through the filament the resistance generates enough heat that the filament glows, producing light.
changing a head light bulb in an odyssey is real easy. first remove connector from back of bulb. then remove rubber cover by pulling on one of the tabs. then remove retaining clip which holds bulb in place. remove old bulb, replace with new bulb, replace retaining clip, then replace rubber cover, and reconnect connector. all done. each light takes about 2- 5 minutes
To have enough bulb or surface area to produce the required amount of light.