0
What else can I help you with?
When my Jeeps heat is turned off for a few minutes then turned on it gives heat but then disepates to cold What is going on?
new heater
Why do your eyes burn after taking out your contacts?
If you're new to wearing contacts your eyes may burn when you take the contacts out. Increased oxygen to your eye can create the burning or stinging sensation. As your wear contacts more regularly your eyes will adapt; if they do not become used to the contacts and your eyes still burn after a week or two, go and see your optometrist or ophthalmologist.
If heater wire harness shorted the heater switch what do you need to do?
From Den052 auto mechanic easiest way is to go to junkyard and remove part of the harness and maybe the switch if it is still good. Splice and replace as necessary. Keep in mind, check heater motor draws too much amperage and will burn out new switch. Usually the case!!!!!!!! Install new heater motor too (real common problem).
Volo S70 has strong coolant smell through airvents when heater is turned on. Vapour smoke comes through airvents. Lasts for ages.Do I need a new heater core?
That's what that sounds like. Dont use your heater at all, its just dumping antifreeze into your car, take it to a dealer.
What is wrong and what should be done if a car emits white smoke from the air vents even if AC and heat are turned off?
Heater core needs to be checked May need to be changed or cleaned answer heater core is bad, replace with a new one
How do you you install heater cables in a Nova?
To install heater cables in a Nova, first ensure the vehicle is turned off and cooled down. Next, locate the heater cable assembly in the engine bay and remove any necessary components for access. Install the new heater cables by connecting them to the heater control and the heater core, ensuring they are securely fastened and routed properly to avoid interference with other components. Finally, test the operation of the heater to confirm proper installation.
How do you change the wick in a dyna-glo heater?
To change the wick in a Dyna-Glo heater, first ensure the heater is turned off and cooled down. Remove the wick adjusting knob and the base of the heater to access the wick compartment. Carefully pull out the old wick and insert the new one, making sure it is aligned properly. Finally, reassemble the heater, ensuring everything is securely in place before using it again.
Water Heater New Caney TX?
Water Heater New Caney TX
How to change dash bulb on zafira heater control?
To change the dash bulb on a Zafira heater control, first, ensure the vehicle is turned off and disconnect the battery for safety. Remove the trim panel around the heater controls, then carefully detach the control unit from its housing. Locate the faulty bulb, replace it with a new one, and reassemble everything in reverse order. Finally, reconnect the battery and test the heater controls to ensure the new bulb is functioning.
1993 Wrangler new water pump new heater coil new radiator getting poor heat from heater?
Your heater core is plugged and you need a thermostat.
How do you change heater on a Ford Transit Connect?
To change the heater on a Ford Transit Connect, first, ensure the vehicle is turned off and cool. Disconnect the battery, then remove the dashboard and any necessary panels to access the heater core. Drain the coolant, disconnect the heater hoses, and remove the old heater core. Install the new heater core by reversing the steps, ensuring all connections are secure before reassembling the dashboard and filling the coolant back up.
How do I install a heater coil for 2003 Lexus gs300?
To install a heater coil in a 2003 Lexus GS300, first, ensure the vehicle is turned off and the battery is disconnected. Remove the dashboard and any necessary components to access the heater core, including the heater hoses connected to it. Replace the old heater core with the new one, reattach the hoses, and reassemble the dashboard. Finally, refill the coolant, check for leaks, and reconnect the battery.
