0
What else can I help you with?
Where is the brake light switch on a 85 dodge Daytona?
The brake light switch on almost all vehicles is located behind the brake pedal lever.
2002 ford explorer brake lights stay on all the time?
check brake light fuse and brake light switch on pedal
1985 bronco brake lights dont work but all other lights do work you replaced brake light switch and bulbs?
Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.
Why are my 97 s-10 brake lights not working?
First check the brake light fuse, then the brake light bulbs and lastly check the brake light switch. If all that checks good you may have a faulty signal switch (AKA the multifunction switch).
Where is the brake light switch for 2003 HD Chevy truck?
Where is the brake light switch for 2003 hd Chevy truck As far as I know, all brake switches are on the top of the brake pedal arm.
When i turn the headlights on all the lights are on but when i push the brakes the rear lights wont bright up.?
Sounds like the brake light switch is defective.Sounds like the brake light switch is defective.
Fix this problem with your carlast night you were driving home from work and the police pulled you over cuz your all the brake light not orking the three of themi replaced all of them and you checked?
usually faulty brake lights are either the brake light switch that senses when you press on the brake pedal, a connector somewhere between the brake light switch and the brake lights or the turn signal switch.
Brake lights do not work all the time replaced brake light switch?
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
All of your brake lights are out checked fuses and are ok?
Bad bulbs or brake light switch.
How do you change the brake light switch on a Lexus RX330?
Changing a Brake-light SwitchI am not familiar with your Lexis, so this answer will be generic in nature and applies to all vehicles requiring replacement of their brake light switch.Here is the procedure:Locate the brake light switch.Disconnect the wiring harness connector and move the harness out the way so you can work without tangling in it, and thus possible damaging it.Remove the switch from its mounting.Install the replacement switch.Reconnect the wiring harness connector to the replaced switch.Properly adjust the newly installed switch so that it is off when the brake pedal is not depressed, but does come on when the pedal is depressed.
Brake lights on your 1999 Trans Am don't work but center light does fuses all good and brake light switch new any ideas?
Either all brake light bulbs are bad, and yes it is common for all the bulbs to fail with in a day or two. Or the signal light switch has an internal problem.
Why will the blinkers on an 81 K-10 pickup work but the brake lights will not?
Check the bulbs. These bulbs are a combination tail light & brake light. Even though the blinkers work, the brake light part might be burnt out. If these are okay, check the brake light switch. It's mounted on the brake pedal. Are the brake lights on all the time or they don't light up at all? if all the bulbs are fine, its more than likely the stop-light switch underneath the brake pedal.
