It means the bending of light.
malleable
Tilting is the process of rock layers bending and buckling from earth's interior layers, or simplified, tilting is when rocks change shape and bend from the inside of earth's layers. :) hope this helps, I actually have a science test on this so its a good thing I came across this
That the material has been weakened from stresses, for example bending.
unsymmetrical bending
Buckling and bending are similar in that they both involve bending moments. In bending these moments are substantially independent of the resulting deflections, whereas in buckling the moments and deflections are mutually inter-dependent - so moments, deflections and stresses are not proportional to loads.Osman E.
buckle means bending
you may have 2 kinds of failures. there is the buckling and the bending. in the bending there is compression and tension, while in the buckling there i torsion and shear. if the beam is restrained but not stiffened you may have Lateral Torsional Buckling, but if it is restrained and stiffened throughout, then you will have Tension Field Action and this would result in a higher load durability.
a fold
Buckling; shriveling, bending, or curling from heating or pressure. (heating, in this case)
This is known as a fold. The process therefore is known as folding or more technically ductile deformation.
Gerald Walter Corney has written: 'The effect of stiffener dimensions on the buckling of webplates subjected to bending'
When a structure ( subjected usually to compression ) undergoes visibly large displacements transverse to the load then it is said to buckle. Buckling may be demonstrated by pressing the opposite edges of a flat sheet of cardboard towards one another. For small loads the process is elastic since buckling displacements disappear when the load is removed.Local buckling of plates or shells is indicated by the growth of bulges, waves or ripples, and is commonly encountered in the component plates of thin structural members.Buckling proceeds in manner which may be either :stable - in which case displacements increase in a controlled fashion as loads are increased, ie. the structure's ability to sustain loads is maintained, orunstable - in which case deformations increase instantaneously, the load carrying capacity nose- dives and the structure collapses catastrophically.Neutral equilibrium is also a theoretical possibility during buckling - this is characterised by deformation increase without change in load.Buckling and bending are similar in that they both involve bending moments. In bending these moments are substantially independent of the resulting deflections, whereas in buckling the moments and deflections are mutually inter-dependent - so moments, deflections and stresses are notproportional to loads.If buckling deflections become too large then the structure fails - this is a geometric consideration, completely divorced from any material strengthconsideration. If a component or part thereof is prone to buckling then its design must satisfy both strength and buckling safety constraints - that is why we now examine the subject of buckling.
Cowboys loved a colorful phrase! This meant to set to with determination and energy. The image is of buckling down to work, buckling on a harness.
it is the ratio of buckling load to applied load
twerk
Ligamentum flavum buckling is a result of a weakened ligamentum flavum, or the ligaments in your vertebrae that allow for bending over and snapping back up. Due to its location in the spine, weakness here can cause localized pain at the site of weakness, shooting pain along any affected nerves and muscle weakness due to decreased neurological efficiency.