Yes. As long as the load stays the same. Voltage equals the resistance of the load times the current or amperage. Or , in this case, as an example, if the load is the same, the voltage is 240 and current is 10 amps. At 120 volts, the current is 20 amps. Current x resistance(or the load)=voltage. With simple math, the equation can be moved around.
A: That will happen anytime the voltage source is not able to provide the power needed for the load. If the load exceed the power available from the source the voltage will be reduced as IR drop from the source
If voltage increases when current remains constant then resistance must also increase. Ohm's Law: Voltage = Current times Resistance.
increases
If the voltage applied across the resistor remains constant, then as the resistance of the resistor decreases, the current through it will increase. Consider Ohm's Law: E = IR In this formula, in order for 'E' to remain constant as 'R' decreases, 'I' must increase. Another form of Ohm's Law: I = E/R If 'E' remains constant, then the value of the fraction increases as its denominator 'R' decreases.
When a rheostat is adjusted from maximum to minimum resistance, the overall resistance in the circuit decreases. As a result, the current flowing through the circuit increases, which can be observed on the ammeter as a higher reading. Conversely, the voltage across the rheostat will decrease, as the voltage drop across a lower resistance is less, which can be monitored using the voltmeter.
Nothing, but the current will increase.
If the resistance increases, while the voltage stays the same, current will decrease. Current = voltage divided by resistance
it dies
If resistance is increased, current decreases. Ohm's Law: current equals voltage divided by resistance.
A: That will happen anytime the voltage source is not able to provide the power needed for the load. If the load exceed the power available from the source the voltage will be reduced as IR drop from the source
If voltage increases when current remains constant then resistance must also increase. Ohm's Law: Voltage = Current times Resistance.
According to ohms law, V = IR, where V=voltage I= current R = resistance the above formula can also be written as I = V/R, here, resistance is inversely proportional to current. In other words, as resistance increases, current decreases.
increases
If the voltage applied across the resistor remains constant, then as the resistance of the resistor decreases, the current through it will increase. Consider Ohm's Law: E = IR In this formula, in order for 'E' to remain constant as 'R' decreases, 'I' must increase. Another form of Ohm's Law: I = E/R If 'E' remains constant, then the value of the fraction increases as its denominator 'R' decreases.
When a rheostat is adjusted from maximum to minimum resistance, the overall resistance in the circuit decreases. As a result, the current flowing through the circuit increases, which can be observed on the ammeter as a higher reading. Conversely, the voltage across the rheostat will decrease, as the voltage drop across a lower resistance is less, which can be monitored using the voltmeter.
The current decreases due to I=V/R. The ammeter reading will decrease as R is increased.
If current sensitivity of a galvanometer is increased, the voltage sensitivity remains the same. Voltage sensitivity depends on the resistance of the galvanometer coil, while current sensitivity depends on the number of turns in the coil. Therefore, changing current sensitivity does not affect voltage sensitivity.