Turning the breaker on allows the power to flow through to the outlets, lights, and appliances on that circuit, so yes power goes to and through a turned on breaker. If the breaker is off, but the main power is on, power still get to the breaker, usually from the bus bar that runs down the middle of the back of the breaker box.
The breaker is probably in the trip position. In the trip position the breaker handle does not go all the way to the off position but positions itself in mid position. Just move the handle of the breaker to the off position and you should feel it reset. There will be a little resistance when moving to the off position. Now move the breaker handle to the on position and there will be another click. This time the circuit should operate as normal.
shut off the power to the box, switch out the breaker and resture the power
Unless you want the power off or there is an overload condition that caused the breaker to trip.
To reset a breaker move the handle completely to the off position. If it had tripped you will feel a little resistance as it goes to the off position. If this doesn't restore the power the breaker is either bad and in need of replacement, or there is a persistent fault in the circuit causing the breaker to immediately re-trip. Breakers are safety devices.
Turn the power off to that plug at the breaker. If at that point you can still get at the broken parts remove them. If not, then replace the plug.
Call an electrician quick- and switch off the breaker for that circuit. It sounds as if there is a loose connection somewhere, and possible fire hazard.
No. Power to all the circuit breakers will be cut off except for the Main power breaker. The Main power breaker (which supplies power to all other breakers and will say 100, or whatever your max breaker box power is, on it )will have power going to it all the time, unless power is turned off outside the house.
shut off the power to the box, switch out the breaker and resture the power
Unless you want the power off or there is an overload condition that caused the breaker to trip.
You need to turn off the power at the circuit breaker.
The voltage before the breaker is from the distribution panel's buss bars. This voltage is controlled by the panel's main breaker. To have no voltage on the terminal of the breaker means that either the breaker is shut off or it has gone into a trip position. If it has tripped push the handle of the breaker to the off position and then to the on position. This should reset the breaker. If the voltage is not present at the output terminal of the breaker after resetting it, then replace the breaker as it has a fault in it.
The circuit breaker resets itself after it cools off, unless the breaker is broken.
you don't you turn off the power in rodricks room with the joshie card and the breaker
By unplugging the device in question or turning off the breaker for the fixture in question.
To be 'flipped off' means to have some display the finger to you. This is a non-verbal communication meaning 'screw you.'
Turn the power off and call an electrician.
The headlight circuit is protected by a self-resetting circuit breaker. Something in the circuit is drawing too much power and the breaker is cycling on and off.
The only way your electronics will work if you turn off the circuit breaker to the surge strip is if they are able to run on battery power. If the surge strip is connected to a UPS (uninterrupted power supply) as many commercial offices are, the electronics will stay operable until the circuit breaker is reset or turned back on if purposely turned off. If the utility service is off, the electronics will stay operable until the power is restored or the UPS power source fails.