0
Does the 1991 Lincoln town car torque converter have a drain plug?
Wiki User
∙ 15y ago
YES IT HAS A DRAIN PLUG. iF WORN PARTICLES HAVE COLLECTED IN THE CONVERTER IT MUST BE REMOVED TO PROPERLY CLEAN. IF YOU ARE JUST DRAINING TO CHANGE TRANSMISSION OIL JUST REMOVE THE PLUG BY POSITIONING IT AT THE BOTTOM AND ALLOW TO DRAIN.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Does 1991 Thunderbird torque converter have a drain plug?
does a 1991 thunderbird torque converter have a drain plug
How do you change the torque converter lock up clutch on a 1991 beretta?
If you have a torque converter lock all the time problem when hot replace solenoid under driver side cover of transmission .
What is the proper tightening torque for a 1991 Toyota pickup oil drain plug?
39nm
What is the location of torque converter solenoid dodge 1991 3500?
It is inside the transmission, on the rear corner of the valve body.
Will the transmission from a 1989 ford ranger fit a 1991 explorer?
yes it will ,but use the torque converter from 89 trans
How do you change the front transmission seal on a 1991 Chevy Camaro?
You will have to remove the transmission and torque converter from the car to get to the front seal.
What is code e39 on 1991 cadillac sedan deville?
Torque Coverter Clutch/Viscous Converter Clutch Engagement Problem
Why does your 1991 Maxima shuts off when you put it in drive or reverse?
Probably because the torque converter lock-up clutch is failing to release.
1991 dodge spirit runs in park but not in gear 2.5?
Sounds like the torque converter lockup switch... you need to take it to a repair shop.
What causes your 1991 Eagle Talon automatic transmission DOHC to cut off when you put it into gear?
Your torque converter clutch is locked up which is usually a solenoid failure.
You have a 1991 dodge ram 250 van an the torque converter locked up in your transmission you bought a brand new one but the holes arent lining up right any suggestions?
If the holes do not line up, you got a torque converter for the wrong year (after 1994), or you will need a flex-plate to match. I bought the torque converter from a trusted transmission parts place.. 2 bolts go in just fine the other 2 are off by like an 8th of an inch
Cylinder head torque sequence for a 1991 pathfinder?
what is the head torque sequence for a 1991 pathfinder
