Yes
Electrical symbols are used on electrical prints to show the location of devices that the architect would like located at specific spots. Two simple circuits in house wiring would be a receptacle circuit and a lighting circuit.
If you are talking about splicing a 40 amp cook top into an existing 3C #10 30 amp circuit then the answer is no. An appliance with that load ampacity needs to have its own dedicated circuit. This would consist of 3C #8 wire cable fed from a two pole 40 amp breaker located in the distribution panel.
Your 110 volt washer receptacle sounds like it is not a dedicated circuit directly fed from the distribution panel as it should be. It sounds like someone has tapped off of one side of the dryer receptacle hot and neutral terminals and run them to the receptacle for the washer. If true, this would have been done in the back side of the dryer receptacles which is located in the wall. You best get it checked out because it is likely the wire feeding the washer receptacle is a #14 rated at 15 amps and is undersized for a 30 amp breaker. A #10 wire has the capacity to be connected to a 30 amp breaker which you should find the dryer's connection to be.
I'm guessing you mean 120 volt, 20 amp receptacle. Look at the receptacle. If the grounding prong is down, the flat slot on the left is your neutral. In a 120v/15 amp receptacle, this slot will be parallel to the hot slot next to it. In a 120v/20 amp receptacle, this slot will be shaped like a sideways 'T'. The reason it is designed this way is so you are able to put either a 15 or 20 amp plug into a 20 amp receptacle, but you can not put a 20 amp plug into a 15 amp receptacle.
For convenience I install the receptacle just above the backboard of the dryer. This way if the dryer is to be moved out of its location it can be unplugged before the move is started. Sometimes the dryer is located in a confined space and it is hard to reach down to the floor level to unplug the dryer with out becoming an acrobat.
Parallel connect the new receptacle to a receptacle in the existing circuit. Black (hot) existing to black (new), white existing to white (new), ground existing to ground (new). Make the ground wire coming into the new receptacle box longer so that it can be looped around the ground screw located in the receptacle box first and then connect to the receptacle without having a break in the wire.
Yes but it's redundant and may cause unnecessary "tripping" of the circuit. The GFCI circuit breaker is intended to protect an entire receptacle circuit whereas a GFCI receptacle is designed to protect only that receptacle and any which are provided power from its load side. (downstream)
The headquarters for Appliance Canada is located on 8701 Jane Street Unit 1 in Concord, Ontario according to the Appliance headquarters company website.
Answer for USA, Canada and countries running a 60 Hertz supply service.In a duplex wall receptacle, with the U ground pin at the bottom, the "hot" blade hole is the smaller of the two blade holes located on the right side of the receptacle. The blade hole on the left is the return neutral connection point.
Electrical symbols are used on electrical prints to show the location of devices that the architect would like located at specific spots. Two simple circuits in house wiring would be a receptacle circuit and a lighting circuit.
8th circuit
8th circuit
this is a circuit in which the switch is located before the load in the circuit
Epidermal cells are supplied with nutrients from blood vessels in the
Sears and TAS Canada are examples of companies that provide home appliance repair services that are located in Canada. The website has appliance spare parts listed as well as service info and a request form.
this is a circuit in which the switch is located before the load in the circuit
The one you most likely can't find is right on the back of the fuse receptacle. It's a fusible link and requires you to replace the receptacle.