If you mean the diagnostic computer (the thing that makes the "check engine" light come on), then no - any dealership should be able to reset this, or you can do it yourself if you buy an OBDII hand-held computer (about $35 on Amazon).
There is no reset button. Disconnect the battery for a few hours, then reconnect and the computer's memory will be erased. You'll have to reprogram your radio setting.
where is black reset button umder drivers dash
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
No, there is not. Most code readers will allow you to reset the check engine light, but you can reset it simply by disconnecting one battery terminal and touching it to the other to discharge capacitors in the system. If this makes you nervous, just pull a battery terminal and leave it disconnected for 45 minutes or so. When you reconnect it, the computer will be reset.
I believe you just lock and unlock it using the keyless entry, if available. If not, try the power locks.
If you do a factory reset then yes you will loose everything.
Remove one battery terminal and touch it to the other to discharge capacitors in the system. Reconnect the terminal and you are good to go. Don't forget to clean the terminal while you have it off.
The on-board computer is factory installed and cannot be 'reset' - it must be replaced.
The procedure is covered in your owner's manual. If you don't have one you can download a .pdf file.
You can usually perform a factory reset by pressing F8 to get to the restore menu on the computer. This will restore the computer back to factory.