answersLogoWhite

0


Best Answer

Yes, the TX valve is an integral part of the air-con system, and thus is pressurised. TX valves are about $40AU trade, probably $60AU retail. Best to get the receiver drier changed at the same time if you haven't had the air-con serviced in the last 2 years. Leave it to the experts - there's no real cheap way out of this one, you could have other underlying problems too. The air-con experts have the right guages + tools to check out possible leaks. Hope this helps you out. Dave.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does the air con system need to be decompressed to change the TX valve?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change an AC expansion valve on a 1991 Toyota Previa please thank you?

the expansion valve it's located inside the line of the A C bottle, but if you open the bottle wish is located on the lef side under the hood , you will need to replace the bottle bacause the system can"t have air inside. you will need to have the system vacumed anf fill by an ac mechanic before you do this you need to take out all the freon of the system and then proceed with tha above


Where is the egr valve located and how hard is it to change?

Realley need to no what your working on and the year.


96 Dodge Intrepid keeps over heating?

Did you bleed the air valve? if you open any part of the cooling system on a dodge intrepid, ie: change the radiator hose or thermostat housing. You need to bleed the air out the Valve. If not the car will over heat.


Can i put a pressure valve ona well pump pipe?

Your meaning is unclear. Your system will already have pressure switch, -why would you need a pressure valve?- or are you unaware of the difference between a valve and a switch.


Do you need to install a combination pressure and temperature releif valve in a chilled water system?

no.


How do you replace the valve seals on a Yamaha moto 4 200?

u need remove cylynderhead then camshaft then rockerarms then use a valve spring compressor then change your valve rubbers.


How do you change egr valve Honda accord?

from what i have been told you don't need to change the valve you just need to get it cleaned. It gets filled with carbon after a time. Try to get it done be for you go for the etest and you will pass. This will also save you a bit of money.


Should you need to replace the valve gasket when you replace the timing belt on a 2000 Hyundai Elantra?

you should only change the gasket if you have to take the valve cover off....... you should only change the gasket if you have to take the valve cover off.......


How do you replace an AC expansion valve on a 2001Chrysler Concord?

The freon has to be removed and the pressure released from the ac system. Then the valve can be removed and replaced. The system will need to have a vacuum pulled and freon put in again.


How do you change the flame on a Bunsen burner?

To change the flame on a Bunsen burner you need only to open or close the air valve to change the combustion reaction.


What is proportional valve?

what is a proportional valve. have a 1992 dodge Dakota and it needs a new one I am told. need a schematic diagram of a braking system to locate it.


Why does the spa draining back into your pool after the system shuts down?

You need to have your check valve replaced.