0
Does the crankshaft sensor cause a 1997 Chevy Malibu to choke before cranking?
Wiki User
∙ 10y ago
A faulty crank sensor would cause no spark and no fuel.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor 2004 Chevy Malibu?
The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.
Where is the crank position sensor for 1997 Chevy Malibu?
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
How do you change crankshaft position sensor?
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
Where is the crank position sensor located on a 1997 Chevy Malibu?
The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.
Where is the crank sensor on a 2003 Malibu?
The crank sensor on a 2003 Chevy Malibu is located on the bottom , right side of the engine. It is positioned near the oil filter and constantly monitors the rotation of the crankshaft.
Where is the crankshaft sensor located in a 2007 Chevy Impala LS?
impala cranking but not starting; replaced fuses, relays, fuel pump and igntion coils.
Why does Hyundai not start crankshaft sensor?
This question is asked poorly. Are you having trouble starting your Hyundai, or having trouble with your crankshaft sensor? Asking your question correctly will get you the correct answer. If your car isn't starting, I would suggest looking over the cranking system. (Battery, alternator, starter etc)... To find out if your crankshaft sensor is a problem, you could use a computer diagnostic tool.
Replacing a crankshaft sensor on a 2000 Chevy Malibu 3.1?
24x crankshaft position sensor--remove drive belt, raise vehicle up in front ( car ramps etc. ) remove the crankshaft pulley, remove the bolt and sensor wiring harness retaining bracket. remove the 24x crank sensor mounting bolts, remove the sensor and withdraw the wiring harness. for 3.1 V6 the 2.2 has a 7x position sensor. good-day !
Where is the crankshaft sensor for a 1995 gmc jimmy?
The crankshaft sensor is by the crankshaft pullie (the balancer)
Crankshaft position sensor on a SHO?
Yes there is a crankshaft sensor
What is the position location of a crankshaft Position sensor on a 2003 Chevy Malibu?
ONE IS ON THE BLOCK, FIREWALL SIDE. tHE OTHER IS BENEATH THE HARMONIC BALANCER ON THE FRONT.
Diagram of crankshaft sensor on Chevy Malibu location to repair?
Yes, It has a crank sensor. Its located above the oil filter on a 2.4 liter engine. Remove the oil filter for easier access.
