0
Does the end-to-end delay experienced by a packet depend on its size?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between end-to-end delay and packet jitter?
End-to-end delay is the time it takes a packet to travel across the network from source to destination. Delay jitter is the fluctuation of end-to-end delay from packet to the next packet.
What is the difference between end to end delay and packet jitter?
End-to-end delay is the time it takes a packet to travel across the network from source to destination.Delay jitter is the fluctuation of end-to-end delay from packet to the next packet.
What are the 4 main types of delays occured in packet switching?
Processing delay Queuing delay Transmission delay Propagation delay
What is the condition for minimum size of the token ring?
propagation delay in the ring/transmission delay of the packet<1
What command is used to determine the location of delay for a packet traversing the Internet?
traceroute
What can RTCP do that RTP cannot?
Report on the degree of packet loss and delay in a connection.
Write the reasons for network delay in TCP algorithm?
The network delay is caused by "handshaking" or the connection-based protocol. This requires an answer (acknowledge) from every transmitted packet. Because the sender must wait for an answer before sending the next packet there will be a delay. The receiver has to indicate that the message was received correctly. In addition, if the packet is not received correctly then the sender must transmit it again. All of these can lead to delays.
Should you say delay in start or delay of start?
It may depend on how you wish to construct your sentence. The delay of the start or the start has been delayed.
What is packet jitter?
Packet Jitter is the variation in the delay of received packets. At the sender they are sent evenly spaced intervals, but due to traffic congestion, improper queuing or configuration errors they come at unequal intervals.
Can you delay cycle by taking birth control pills?
Yes, skip the 7 inactive pills and go straight to the next packet of pills, the day after taking the last active pill, in packet 1.
What is pdv?
PDV stands for packet delay variation. It is a term used in computer networking which is the difference in the end-to-end one-way delay between selected packets in any ignored lost packets.
What is latency on a network?
adding 50 meters on the length of the network
