Some do, some don't. Some even have a metal gasket. Just depends on the vehicle you are driving.
The oil drain plug seal is located on the oil drain plug itseft. So Next time you have your oil change. Since the oil drain plug is going to be out to drain oil then replace the seal with a new one. The seal goes right on the plug itseft. easy job.
Locate the drain plug on the oil pan, remove it, and let the old oil drain. Then locate and remove the oil filter, wipe some oil on the rubber seal of the new filter, then replace the drain plug.?æ
An oil filter gasket is the rubber seal at the bottom of the oil filter that seats on the engine.
I believe they use rubber latex
There is a rubber plug in the center of the back cover. Oil level should be at the bottom of the hole.There is a rubber plug in the center of the back cover. Oil level should be at the bottom of the hole.
An oil filter gasket is the rubber seal at the bottom of the oil filter that seats on the engine.
The rubber plug just covers the weep hole to hide any minor leakage from the water pump seal.The rubber plug just covers the weep hole to hide any minor leakage from the water pump seal.
They seal oil/water/dirt out of the plug tube.
Rubber.
The seal under the valve cover around the plug tube has failed.The seal under the valve cover around the plug tube has failed.
It is a small round rubber are plastic seal with a hole in the center of it, And it goes over the valve stem in the head to keep oil from running down and into the combustion chamber- where the spark plug goes into the head. If you remove the valve cover you will see several springs and they go over the valve stem and seal.
At the top of the filter is a rubber seal. Sometimes when you remove the old filter that rubber seal stays in place and when you screw the new filter on the oil will spew out between the two seals. So take the filter off and check for the old seal. If that is not the problem you may have cross threaded the new filter or tried to tighten it too much and rolled that seal over. It needs to be tight but not torqued down.