the answer is no you only have to remove the car horns and the large under tray to make way for removal.
The thermostat is located inside of the top radiator inlet. The inlet is behind the alternator, and the alternator will have to be removed.
Changing the rear brake pads on a Vauxhall Vectra is similar to another device and can be done by hand or by a mechanic. The original brake pads need to be removed but not any of the brake wires. Then new pads should be put on.
Changing a thermostat in a 1999 Hyundai Accent is very easy. To locate the thermostat, follow the upper radiator hose. The thermostat can be removed by taking off the housing retaining bolts. After the bolts are removed, take the thermostat out and replace with a new one.
To change alternator belt on a Suzuki Swift, first disconnect the negative cable from the battery terminal. Then disconnect the electrical wires going to the alternator and remove the bolts holding the alternator to the frame. Slip off the old alternator belt and replace with another. Finally, put back all the bolts and cables previously removed or disconnected.
yes, once the alternator is removed from the bracket, the axle and exhaust interferes with the removal of the alternator from the vehicle.
The alternator bolts need to be loosened so that the alternator can slide and take pressure off of the belt. Remove the old belt (any belts blocking passage may have to be removed as well.) Remove then replace the belt, and move the alternator to the side to tension the belt while tightening the bolt. Reconnect the battery.
Changing a radiator in a 1997 Pontiac Grand Am can be a difficult task. To remove the radiator, all of the radiator hoses will need to be disconnected from the radiator. The transmission lines will also need to be removed. After all of the hoses are disconnected, remove all of the clips that are holding the radiator in place. Lift the radiator up and place with a new one. All the hoses and clips will need to be put back in place with the new radiator.
Not wishing to be rude, but if it is not obvious to you, perhaps you should not be tmepted to touch it. On smaller engined models it is at the rear of the engine, driven by the belt and to remove it you need to approach it from underneath and preferably having removed the starter motor.
There are several steps to changing a water pump in a 2001 GMC Yukon Denali. You must first make sure the engine is cool, and drain the radiator of coolant. You will then need to remove the air duct and housing. You will also need to move or remove the radiator hose, radiator fan shroud, serpentine belt from the alternator, water pump pulley, and old pump gasket?æto access the water pump. You can then replace the water pump, and then replace the parts that you removed.
follow the hose from top of radiator-the hose leads to a neck that is partially buried by the alternator that yoke is the top of the thermostat there are a couple of brackets that have to be removed in order to change it.
The radiator drain plug on a Chevrolet Corsica is the lowest, skinniest hose on the back of the radiator. The radiator cap will have to be removed to allow for fast draining after this hose is removed.
The alarm is built into the body computer and can not be removed. If you are blowing fuses, you have an short to ground or a current overload.