answersLogoWhite

0

Door lock 1995 geo

Updated: 8/16/2019
User Avatar

Wiki User

15y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Door lock 1995 geo
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find an inside door lock switch for a 1995 Geo Prizm?

Toyota dealer parts department.


How do you get the spare tire off of a 1995 Geo Tracker?

Our 1995 Tracker Sidekick has a spare on the rear door , it has a tire lock that your ignition or door key should unlock, however our keys do not fit the lock. I may have to drill or grind it off and replace it with anotherone


Can you take a door on a 1997 Geo Metro apart the same way you take apart the door for the 1995 Geo Metro?

yes


Does the open door light drain the battery on an 1995 geo prizm?

yes


How do you remove a lock cylinder from a 1994 Geo Prizm?

Take the door panel off, remove the moisture barrier and access it from the inside of the door. Should be a large metal clip holding it on to the door. Of course, you'll have to disconnect the lock rod from it too.


How do you lock the hubs on your Geo Tracker?

lock them in tight.


Where can you find a free manual to a 1995 geo prizm?

geo prizom 1995


I have 1995 4x4 Geo Tracker with a bad auto transmission will auto transmission out of 1998 4x4 Geo Tracker fit in 1995 Geo Tracker?

i have 1995 4x4 geo tracker with a bad auto transmission will a auto transmission out 1998 4x4 geo tracker fit in 1995


What is the weight of a 4 door Geo Metro?

(Pre 1995) I see the weights on two door hatch backs are around 1,650 lbs. A four door hatch back may be another 50lbs. If you are talking about 1995 and newer, sorry but don't know. Regards,


How do you replace the backup bulb 1995 geo prizm?

1995 geo trunk lid bulb


How do you adjust the clutch pedal on a 1995 Geo Prizm?

how much cost to change a clutch for a geo prizm 1995


How to replace a 1997 geo prizm lock?

If you mean the door lock cylinder...remove the interior door panel. On the back of the door handle there are 2 10mm hex bolts. To the outer edge of the door there is an access hole. With an extension, remove the 10mm bolt that holds the lock cylinder and door handle together. Reach in and push the nylon retainer that holds the rod into the cylinder (yellow on driver side, white on passenger side) and remove it. A slight twist of the cylinder will remove it from the door handle. Replace in reverse order.