Want this question answered?
DID YOU TRY CHANGING OUT THE BATTERIES ON THE REMOTE??
activators; inhibitors
To program your keyless remote, locate the dark green program enable wire and connect to the wire enable terminal. Insert your ignition key and turn the switch to on while depressing either button on the transmitter. Disconnect the program enable wire terminal and remove the key from the ignition.
It is the ignition switch, remote keyless entry receiver, tire pressure monitor computer, antitheft chipped key computer
the battery in your remote coulb be going bad or, the master door lock switch could be bad. this switch is very costly $289.00. you may want to check the switch with a volt meter before you purchase a new one.
Open the driver door, sit on the seat and leave door open. Insert key in ignition. Turn to AC (instrument lights on), and switch off. Repeat 3 times fast. Depress the spring light switch on the door panel 3 times (the cabin lights will switch on and off). Press the remote unlock button 3 times. Exit the car, close the door and try the remote. If it doesn't work try again, or check your remote battery.
A remote light switch is a switch that triggers a light by remote. You can get one installed through your local home department store and have it rigged up to a universal remote.
Perhaps the enabling switch concealed in the glovebox has been turned off.
Turn ignition switch to 'On'. Press valet button 3 times, you will hear one beep, press 'lock' on remote. Press valet button 4 times, you will hear two beeps, press 'unlock' on remote. Should be programmed now to lock/unlock car.
Allright with a voltimitter check your switchs so when you roll them up or down you have power to the switch if not its your door switch. if you do have power check if you have power to your motor. there is no relay switch theres only fuses.
get in car lock doors with door lock switch, insert and withdraw the key six times in 10 seconds plenty of time be precise, watch for the turnsignal to flash twice. turn key to on posistion push any button on the first remote keyless fob. if the car saw the signal the turnsignals will flash twice to program the next keyless fob unlock the door and relock the door and push button on second remote. Up to five remotes can be introduced to the car. To exit the keyless programing either turn the key off or open the drivers door. If the car does not flash when pushing the remote then look at the FCC number on both remotes they should be the same. get in car lock doors with door lock switch, insert and withdraw the key six times in 10 seconds plenty of time be precise, watch for the turnsignal to flash twice. turn key to on posistion push any button on the first remote keyless fob. if the car saw the signal the turnsignals will flash twice to program the next keyless fob unlock the door and relock the door and push button on second remote. Up to five remotes can be introduced to the car. To exit the keyless programing either turn the key off or open the drivers door. If the car does not flash when pushing the remote then look at the FCC number on both remotes they should be the same.
A lamp holder that turns on from a wall light switch not a switch on the device.