could be hundreds of reasons... vacume lines, pump... air flow meter... injector pump... brake light switch....could be fault in wireing loom.... if there is no major side affect of haveing the light on just take the bulb out or ut a bit of tape over the light.
When you turn the ignition on the CHECK ENGINE light will not light up at all.
If its vectra b to reset ECU you have to turn key so all display leds light up then off and do it 8 times if i remember rightly, this resets ECU to factory settings.
It is a fault code on the ECU. It is not a service light.
your map sensor is fine , there is a short somewhere so your ecu is not reading it your map sensor is fine , there is a short somewhere so your ecu is not reading it
To reset the check engine light on a 1994 Honda Civic locate the fuse box in the engine compartment. Find the ECU fuse and pull it off for at least 5 seconds. This will erase all codes on the ECU.
The check engine light comes on when the ECU detects a problem with the emission system in the vehicle. Have the ECU scanned to retrieve the code that will tell you what part of the system is being effected.
the car will run rough, and the check engine light will be on. and depending on the car, it could possibly not run at all
Get the ecu codes read, there is a fault code listed in the engine ecu
There is no chip it is controlled by the ECU.
An ECU is essentially the brain for a 1999 GMC Suburban. Without an ECU the truck will not be able to operate at all.
The check engine light is all because of the ECU has detected a problem with the emissions system. Have the ECU scanned with an OBD2 scan tool. This will retrieve the code that has been set by the computer. This code will tell you what part is being effected but not necessarily the defective part.
A 2000 Honda Accord check engine light will stay on if the ECU is not reset. To reset the light remove the ECU fuse from the engine bay fuse box. Reinsert it after 5 seconds.