0
What else can I help you with?
How do you fix horn in 1998 Pontiac Sunfire?
how to check fuse for horn in a 1998 Pontiac sunfire
How do you replace the horn in a 1998 Pontiac Sunfire?
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
Cram shaft problem sunfire 1998 motor 2.4?
what is the specification of the cram shaft of sunfire 1998, motor 2.4
1998 Pontaic sunfire Engine Error Codes P0141.02?
http://autorepair.about.com/cs/troubleshooting/l/bl_obd_1.htmshows this code:P0141 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)FriPilot
Where is the carbourater on a 1998 Sunfire?
To the best of my knowledge, this is no carburetor on any Sunfire. I believe that they were all fuel injected.
How do you remove the ECM on a 1998 Pontiac Sunfire?
To remove the ECM (Engine Control Module) on a 1998 Pontiac Sunfire, first, disconnect the negative battery terminal to prevent any electrical shorts. Then, locate the ECM, which is typically found under the dashboard or near the passenger side firewall. Unplug the electrical connectors attached to the ECM and unscrew any mounting bolts securing it in place. Finally, carefully pull the ECM out of its housing.
What is the gas tank capacity of a 1998 Pontiac Sunfire?
the 98 sunfire haz a 57.2 litre gas tank
What year sunfire fenders can you interchange with a 1998 sunfire?
I believe 1995 through 2005 fenders are all the same. Surely a 1996 and 1997 fender will fit a 1998 model.
Where is the thermostat on a 1998 Pontiac Sunfire?
Off the water pump
What kind of freon is used for a 1998 Pontiac Sunfire?
R134a
Where is the thermostat located on a 1998 Pontiac Sunfire?
check this site------>
How do you replace windshield washer pump in 1998 Pontiac sunfire gt?
To replace the windshield washer pump in a 1998 Pontiac Sunfire GT, start by disconnecting the negative battery cable for safety. Remove the washer fluid reservoir by unbolting it, then disconnect the hoses and electrical connector from the pump. Replace the old pump with a new one, reconnect the hoses and electrical connector, and reattach the reservoir. Finally, reconnect the battery and test the pump to ensure it's working properly.
