B. Electrical panel
plumbing line floor joist electric panel ground Electrical wire sheathing should not project more than about one inch into any device that uses a cable clamp to secure the cable to the device.
Electrical wire sheathing should not project more than about one inch into the electric panel.
No, it shouldn't. Electrical work revolves around recommended and non recommended procedures. In this case, the sheathing needs to project no more than about one inch into the electrical panel.
The electric panel is something into which electrical wire sheathing shouldn't project more than about an inch. There are recommended guidelines, and non recommended actions, in electrical work. This is such a case, of recommended actions regarding sheathings and panels.
Electric wire sheathing should not project more than one inch into the electric panel.
Electrical wire sheathing should not project by more than one inch into where the wire terminates into a specific device. An example is a junction box or branch circuits terminating into a distribution panel.
Electric Panel ---------------------------- Based on the answers you have proposed, Electric Panel is the correct choice. However, I do not know of any requirement in the NEC that prohibits the sheathing from extending further into the panel. There is a requirement that it must extend through the connector, but I know of no NEC requirement on when it must stop. --Sparkfighter
One inch.
electric panel
Electricity is generally not involved in a plumbing project, unless you plan to install recessed lighting over the shower area. For the most part, plumbing and wiring are kept separate.
MEP is an inevitable part of any construction project, whether it is commercial or residential. It requires this kind of engineering in the initial phase.
If the project is completed,i wouldn't worry about it. But if the plumbing ,electrical,or hvac needs to be inspected, the inspector will place his sticker,with signature, on the permit,which better be there.