0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What types of flags can be flown at veterans memorials?
American flags, pow mia flags . . .
What is the difference between microprocessors 85 and 86?
85 is a 8 bit processor,number of flags are 5 and memory capacity is 64KB while 86 is a 16 bit processor ,number of flags are 9 and memory capacity is 1 MB.The main difference between 8085 and 8086 is that 8086 uses pipelining.
What micro controllers for a digital control system?
for dcs 8086 and 8085 are usually used as base microcontroller as these have indication flags which r signaled to registers
How many type of instructions does the 32-bit Intel 8086 have?
The Intel 8086/8088 is not a 32 bit machine. It is a 16 bit machine. It has 72 instruction types.
When does the overflow flag in 8086 set?
In the 8086/8088, the overflow flag is set when the result of an arithmetic instruction exceeds the bounds of the signed representation of a number. This is not the same as the carry flag, which is used for the unsigned representation. Both flags get set as needed. You decide which one to pay attention to.
What is the basic difference between instruction RET and IRET in 8086 microprocessor?
RET pops the PC off of the stack, while IRET pops both the flags and the PC off of the stack.
What are the flags on the top of Mt. Everest used for?
There are two types of flags that can be found on the summit of Mount Everest. Those of the country where a climber has come from and prayer flags that are left for the mountain gods.
Which IC is used as clock generator in 8086?
The 8086 Microprocessor operate to require frequency that is provided by clock generator to 8086 Microprocessor and also Synchronization various component of 8086.
What are applications of 8086 microprocessor?
8086 main application is to evaluate the arithmetic operations in any systems that uses 8086
How many different flags are being used in the UK?
There are currently four different types of flags being used in the UK at this very moment in time. These flags are as such: Ireland, Wales, Union Jack and Scotland's flag.
How you can change value of flag register of 8086?
In general, the best way to change the flag register is to perform some operation that sets or clears flags. If you are careful, you can also push the flags onto the stack, manipulate the stored value, and then pop them back off. This is often the method used by a debugger to set the single step flag. When using this method, it is important to not set an inconsistent combination of flags.
Which is better in 8086 and 8051?
If you mean greater (more) 8086.
