An IP address is the same thing whether you use Linux, Windows, OS X, Haiku, ReactOS, DOS, UnixWare, etc.
An IP address is a "unique" identifier for a host on a network.
swagg
ifconfig <if device> inet <ip address>
1. dhclient -r This releases the current IP address lease 2. dhclient This requests a new IP address.
Run /sbin/ifconfig or on the terminal jst type: ifconfig -a
If your router assigns IP addresses via DHCP, it is better to configure the router to pre-assign IP addresses to certain hostnames.If you do not have a DHCP server running in your router, you can specify an IP address for a network interface with the ifconfig command. For example:ifconfig eth0 192.168.20.10
type on a Linux terminal: ifconfig Note: it is ipconfig in Windows.
Answer In the Windows command prompt, type "ipconfig". That will list basic information, including your IP address, of all your network interfaces. Be warned this will only return you your local IP address. That means if you're on a LAN, then you'll get the IP address of that network and not your WAN IP address. *************************** Note: It is "ifconfig" on a Linux operating system.
ping [hostname] or ping [IP address]For example:ping wiki.answers.comorping 127.0.0.1
This may change.If you are Windows open Command Prompt and type ping linerider.com. Do the same on Linux but just with the shell.From both you will see an IP number such as 1.2.3.4. That will be the IP address of the web server hosting the site.
ifconfig is the usual favorite for looking at the configuration of network interfaces. IT'll provide detailed information about them all, not the least of which is any assigned IP address.
The IP address for the cars.com website can vary due to the use of content delivery networks and server configurations. You can find the current IP address by using the command prompt (Windows) or terminal (Mac/Linux) and typing ping cars.com. This will return the IP address that's currently resolving for the website. Keep in mind that IP addresses may change over time.
Assuming you're not using DHCP (in which case it would be set automatically), you would use:ifconfig eth0 10.10.0.1substituting the correct interface card and IP address, of course.