0
just farking use a bit of double sided tape mate
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you fix a hole in a wall?
Get a plastic sheet and then cement it
How do you fix a hole in hard plastic then drill it?
JB Weld
Water floor galant?
I had the same problem and fixed it. Your air conditioner run off tube is plugged. It is located on the drivers side on the floor near the center console. It is in the corner of the floor board. If you pull the carpet up, you will see a plastic L shaped tube. To fix the problem, just drill a hole in this tube, and put a clothes hanger into the hole to release the clog. After that, fill the hole with Epoxy.
How to quick fix a dodge caravan se 2000 window?
The only fix not involving removing the door panel is to use plastic and tape to fill the hole.The only fix not involving removing the door panel is to use plastic and tape to fill the hole.
What is the fix for a low pressure fuel leaking from a small plastic tube near the top of the pump?
The fix is replacing the leaking part.
How do you fix hole in gel ice pack?
You can try fusing some plastic to it, but the reality of it is that it's done for. Toss it, get a new one.
How would one fix a hole in a gas tank on a 1999 Plymouth Voyager?
There is no safe way to repair a plastic fuel tank, you must replace it.
How do you fix the ozone hole?
To fix the ozone hole, stop using CFC's. They are the ones depleting ozone.
How do you fix hole in gas tank?
take it to the fix place...................................................................................................................................................................................................................................................................
How do you replace or fix the coolant tube behind the water pump on a 92 Geo Metro 1.0L The coolant tube seal to the engine block has been broken?
Ouch, tough one. You might be able to have a machine shop drill and tap a hole that would let you screw a pipe in to hook up a tube. It would depend on what is directly behind that hole in the engine. Consult a machine shop or mechanic.
Leaking plastic tube fits into intake manifold and into behind belt tensioner 45 degree bend 96 regal 3.8 what is it and how to fix?
This tube is the bypass tube. To replace it, you need to remove the belt tensioner. You can get the tube at any parts place, but make sure you replace the orings for the tensioner to prevent any further leaks.
How do you fix a Kitchen Aid washing machine that overfills with water?
In the back will be a water level switch probably hamburger shaped and about 2 to 21/2 inches across with two wires to it and a plastic tube going to the drum. Take the tube off and check the tube for blockage by blowing through it, tube should not be blocked. If tube was clear, change switch. If tube was blocked, reassemble and try it out.
