That is a round steel plate bolted to the output end of the crankshaft to which the clutch or the torque converter is attached and into the circumference of which are milled teeth into which the starter pinion gear engages that, by its rotational inertia, smooths the pulsations of the combustion stroke.
It makes the engine run smoother.
Typically, it is more cost effective to replace the flywheel than it is to repair it. A new flywheel will be less likely to cause you to have to pull the engine or drop the transmission which probably is going to cost you a half-day's worth of labor.
Expensive, especially if it's getting older! This is because it's a foreign car, and foreign cars are always more expensive to repair.
Higher theft rate, higher probability of an accident, more expensive to repair.
Not really. It is also very expensive to repair.
rickracers.com flywheel magnet repair kit
Because it is usually more expensive to repair newer vehicles since the parts are more expensive.
You have to repair your car using your own pocket money and that would be so expensive.
no it is not that expensive to repair
The repair cost, has to be more expensive than the insurance company believes the car is worth.
Remove the trany and you will see the flywheel bolted to the rear of the motor. Remove the bolts & replace the flywheel. Check the starter as a bad starter can chew the teeth off of a flywheel very quickly.
Depending on the damage of the car in question it can be less expensive to have a professional repair the car. Small dents and scrapes however can easily be managed by the car owner for much less money.
No, there is no need to replace the flywheel but it is a good idea to have the flywheel surface machined.
expensive