Gas tank removel 1995 dodge neon?

Answer 1

Fig. 4 Fuel Pump Module Electrical Connector REMOVAL

# Perform fuel system pressure release. # Drain fuel tank. # Raise vehicle on hoist. WARNING: Wrap shop towels around hoses to catch any gasoline spillage. # Disconnect fuel pump module electrical connector # Disconnect the fuel tubes from fuel pump module. Disconnect fuel supply tube from chassis tube # Support tank with transmission jack. Loosen tank mounting straps and lower tank slightly.

# Disconnect fuel filler tube and filler vent tube from filler hose at fuel tank. # Disconnect fuel filler vapor relief tube from tee connecting it to the tank vapor relief tube and EVAP canister tube. # Disconnect vapor line from EVAP canister tube. # Remove tank mounting straps and lower tank. INSTALLATION

# Position fuel tank on transmission jack. # Raise tank into position. Connect fuel filler tube tank inlet nipple. # Tighten fuel tank strap nuts to 23 Nm (250 in lb) torque. Remove transmission jack. Ensure straps are not twisted or bent. # Attach fuel tubes to pump module and chassis fuel tube. # Connect fuel vapor tube to tee, then to EVAP canister tube. # Attach electrical connector to fuel pump module. # Lower vehicle. # Fill fuel tank, install filler cap, and connect battery cable. CAUTION: When using the ASD Fuel System Test, the Auto Shutdown (ASD)Relay remains energized for either 7 minutes, until the test is stopped, or until the ignition switch is turned to the Off position. # Use the DRB or equivalent scan tool ASD Fuel System Test to pressurize the fuel system. Check for leaks.