check the tranny fluid ASAP. or it could just mean your tranny is worn out. but check that fluid now
Why is your 1993 Altima Nissan making a clicking noise but does not start?
Cicadas
A bad resistor can cause your BCM to make a clicking sound. The clicking noise can be caused by the relays and replacing the BCM will fix the problem.
If the Chrysler is only making a clicking noise and will not start, check the starter. Also check the alternator, and the battery. The starter solenoid is more than likely the reason the car is clicking and not starting.
It is out of balance..Replace IT!
ifs its a long loud clicking noise its the transmission solinoid pack perfectly normal this applies to a a604 transmission
The brakes may make a clicking noise if the caliper is going bad. I just changed the brakes and the rotors and discovered my car was making a clicking noise. The garage I took it to replaced the caliper, so now it doesn't make the noise anymore.
That is the neutral safety switch making the click sound.
The control systems on modern cars can cause a ticking noise from the transmission. Chrysler product built from about 1999 to 2009 very often make a "Grick" noise when put into drive from park. This noise is the control system making a very fast clicking noise. It also means the sound deadening pad is loose or damaged.
it is not the hazard system, but comes from the speedo cable which is routed behind the dashboard thus making it sound like the flasher unit.
The a/c clutch needs to be replaced or repaired.
the clutch on your A/C compressor needs to be replaced.