answersLogoWhite

0


Best Answer

How Caves Form in Limestone

That is such a common question on ‘Answers’ I wrote this single reply! The technical terms are introduced by capital initials.

Most of the world’s caves are in Limestone.

Caves need three materials: a soluble rock like Limestone or Gypsum, water and Carbon-dioxide (CO2).

Their host limestone also needs to be of appropriate physical structure and raised into hills, then subjected to reasonably consistent precipitation for many tens or hundreds of thousands of years.

Limestone is a sedimentary rock of which the world’s greater proportion was laid down in warm, relatively shallow, seas. The rock was laid in horizontal layers – Beds – separated by Bedding-planes which generally reflect geologically-brief changes in the environment. The suite of beds is known as a Formation, generally named after its “type area”.

Later continental uplift (tectonic processes) raise the formation along with its underlying rocks, usually tilting and folding it to at least some extent in the process. Since most rocks are brittle they cannot take much stress, and limestone beds crack into grids of fine fractures called Joints. The uplift and folding often also causes Faulting – major breaks with the rock mass one side of the Fault Plane being raised, lowered or moved horizontally past that on the opposite side. (Note: Plane – the “Fault Line” sometimes misused as a political metaphor is that of the fault-plane cutting the land surface.)

Now we have the hills, next we need rain-water that has absorbed atmospheric CO2 to create Carbonic Acid (weak, natural soda water in fact!). It may be augmented by acids from the soil, too. This solvent permeates through all those joints, bedding-planes and faults; flowing very, very slowly under considerable pressure applied by its depth, from its sinks on the surface to its springs at the base of the formation. In doing so, it dissolves the limestone (chemical weathering), creating meshes of tiny micro-conduits that over many tens of thousands of years coalesce and capture each other to form cave passages.

Once this happens, the rate of erosion can increase – though still to perhaps only a few millimetres per thousand years under generally temperate climates.

A cave, or a series within a cave system, that still carries its formative stream is called “Active”, and is still being developed.

Surface changes such as the valley floor being lowered by erosion, or down-cutting within the cave by its stream, changes the water’s route and the original, now dried-out, stream-way is called “Fossil” or “Abandoned”. Such passages may be filled with silt left by floods as the main flow gradually abandons them; or may become richly decorated with Speleothems – calcite deposits such as stalactites and stalagmites precipitated from ground-water still oozing through the joints in the limestone above the cave. In time such passages may start to break down as there is no stream to dissolve away slabs falling from the roof as permeating ground-water attacks the rock above.

In the end, surface lowering of the landscape as a whole, breaches and destroys the cave. Nothing is permanent in Nature!

Caves in limestone are also parts of Karst Landscape. i.e. a landscape developed by the dissolution of limestone, giving surface features like Dolines, Limestone Pavement, and in the tropics, distinctive hills such as those represented in Chinese Willow-pattern images. ‘Karst’ is from the Slavic word ‘Kras’, the name for its world type-area.

@@@@@

The above is purely an introduction to a vastly more complex and subtle series of processes, of course, and you need to refer to appropriate text-books on geology and cave studies to learn them.

The scientific study of caves is Speleology – embracing geology, hydrology, Biology, Archaeology and other disciplines.

Simply visiting caves to enjoy them for their scenery and the physical and mental challenges they present, is called Caving, though you can’t study a cave unless you can negotiate its obstacles. The enthusiasts are simply Cavers throughout the English-speaking world – you see “spelunkers” sometimes on ‘Answers’ but it's an old slang word not found in caving literature.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Groundwater forms caves and sinkholes by the process of?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What forms when limestone found in the earth has been eatin away?

When limestone is eaten away, it forms various features such as sinkholes, caves, and underground tunnels. This process occurs due to the dissolution of the limestone by acidic groundwater. The result is the creation of unique and sometimes expansive underground landscapes.


What forms when groundwater erodes limestone?

Caves.


Can Erosions happens underground?

Yes, this is what forms sinkholes, and limestone caves.


What are the three causes of sinkholes in Florida?

Florida has a lot of porous limestone underneath the surface. It can hold lots of water in underground aquifers. As groundwater flows through the limestone, it forms an eroded landscape called karst, known for caves, springs and sinkholes.


Is water in caves acidic?

yes, because it is formed by groundwater charged with CO2 (carbon dioxide) which forms carbonic acid


What is groundwater that forms caves like?

Acidic ground water (rain-water that has absorbed atmospheric carbon dioxide to form carbonic acid) forms caves by dissolving the limestone as it flows through the joints & other discontinuities in the rock mass.


What forms when limestone found in the earth has been eaten away?

Dissolution features such as dolines and sink holes as well as caves are common when limestone wihin the earth is dissolved.


What is formed when rock above a cave collapses it forms a?

When rock above a cave collapses, it forms a sinkhole. Sinkholes are depressions in the ground that are often caused by the erosion of underground caves or channels.


What is the type of landscape where you have caves and deep valleys and sinkholes?

There is not a particular kind of limestone needed to make a canyon or valley. They and caves form through erosion of most limestones, but their development is subject to a good deal of local geological and hydrological control.


How does ground water create certain features?

Groundwater forms features such as caves by moving downward due to gravity. Water follows the path of least resistance and slowly erodes whatever it passes over.


What can help a sinkhole?

Sinkholes may capture surface drainage for running or standing water, but may also form in currently high and dry locations. The state of Florida in the USA is known for having frequent sinkholes, especially in the central part of the state. The Murge area in southern Italy also has numerous sinkholes. Sinkholes can be formed in retention ponds from large amounts of rain. Sinkholes are usually but not always linked with karst landscapes. In such regions, there may be hundreds or even thousands of sinkholes in a small area so that the surface as seen from the air looks pock-marked, and there are no surface streams because all drainage occurs sub-surface. Sinkholes have been used for centuries as disposal sites for various forms of waste. A consequence of this is the pollution of groundwater resources, with serious health implications in such areas. Sinkholes also form from human activity, such as the rare but still occasional collapse of abandoned mines in places like West Virginia, USA. More commonly, sinkholes occur in urban areas due to water main breaks or sewer collapses when old pipes give way. They can also occur from the overpumping and extraction of groundwater and subsurface fluids. The Great Blue Hole, located near Ambergris Caye, Belize. Many sinkholes are also found in Northern Michigan. These are prominent in Alpena County in Northeast Michigan. In Lachine,Michigan there are five sinkholes that are found to be very deep , and within two miles of each other. Alpena's visitor information cites their sinkholes as an attraction for visitors to the area. In August 1998 a 16 year old Alpena boy survived a 200+ foot fall in an open sinkhole 3/4 a mile off of Leer road in Lachine, Michigan (The Alpena News 8-21-1998). A majority of sinkholes in Alpena are also found underwater. Many divers explore these on a regular basis. When sinkholes are very deep or connected to caves, they may offer challenges for experienced cavers or, when water-filled, divers. Some of the most spectacular are the Zacatón cenote in Mexico (the world's deepest water-filled sinkhole), the Boesmansgat sinkhole in South Africa, Sarisariñama tepuy in Venezuela, and in the town of Mount Gambier, South Australia. Sinkholes that form in coral reefs and islands that collapse to enormous depths are known as Blue Holes, and often become popular diving spots. Image of the entire surface water flow of the Alapaha River near Jennings, Florida going into a sinkhole leading to the Floridan Aquifer groundwater. In the United States, the most damage from sinkholes tends to occur in Florida, Texas, Alabama, Missouri, Kentucky, Tennessee, and Pennsylvania. The overburden sediments that cover buried cavities in the aquifer systems are delicately balanced by groundwater fluid pressure. The water below ground is actually helping to keep the surface soil in place. Groundwater pumping for urban water supply and for irrigation can produce new sinkholes in sinkhole-prone areas. If pumping results in a lowering of groundwater levels, then underground structural failure, and thus, sinkholes, can occur.


How water forms caves?

The acid in the water forms it