silicone brake fluid, I think it is dot 6 or something like that, you have to remove all of the old fluid first, can't mix at all.. but that will have less brake fade and higher bubbling temps. they use it in race cars.
yes because brake fluid wont wear out as much No, brake fluid will destroy the seals in the power steering system.
No. Brake fluid is not a petroleum product. Power steering fluid is. Petroleum product will swell and ruin rubber part's brake system is full of rubber parts. You will destroy your brake system using power steering fluid.
I have the same problem. Anybody have any ideas? Check brake reserviour fluid level. As mileage increases on your vehicle, the brake pads and shoes(if used)wear, pushing more fluid to the wheels and causing brake fluid level to become low.
Four Possible reasons... Low brake fluid - check the brake fluid level in the master cylinder Emergency brake is on - check emergency brake Low brake fluid pressure - such as a broken brake line or a bad wheel cylinder. Check the master cylinder to see if it is empty. If you add fluid and pump the pedal you will probably see brake fluid on the ground or on the inside of the tires. Possibly a bad master cylinder. - The fluid will stay full but you will have no or little brake pressure. Could be air in the system as well. BE CAREFUL If you happen to add power steering fluid or transmission fluid to the master cylinder instead of brake fluid you will destroy the system. Make sure you use ONLY brake fluid and clean the master cylinder cap off with a clean rag first so no dirt gets into the braking system.
It uses brake fluid in the brake fluid reservoir. The clutch fluid (brake fluid) is fed by the brake fluid reservoir. The clutch fluid reservoir is just beneath the brake fluid reservoir. So, add fluid to the brake fluid reservoir to fill the clutch fluid, also.
Four Possible reasons... Low brake fluid - check the brake fluid level in the master cylinder Emergency brake is on - check emergency brake Low brake fluid pressure - such as a broken brake line or a bad wheel cylinder. Check the master cylinder to see if it is empty. If you add fluid and pump the pedal you will probably see brake fluid on the ground or on the inside of the tires. Possibly a bad master cylinder. - The fluid will stay full but you will have no or little brake pressure. Could be air in the system as well. BE CAREFUL If you happen to add power steering fluid or transmission fluid to the master cylinder instead of brake fluid you will destroy the system. Make sure you use ONLY brake fluid and clean the master cylinder cap off with a clean rag first so no dirt gets into the braking system.
NO NO NO!!!! OMG I hope you did not try that already. Break fluid and powersteering fluid have different properties for different pressures, they are not the same thing and if you put break fluid in your power steering system you will destroy your car.
Yes. Normal brake fluid is actually synthetic
It is important to maintain the brake fluid levels in a car. The brake fluid type for a 2002 Grand AM is DOT 3 brake fluid.
In a braking system, if the part has failed or is leaking, then it has to be replaced. There are no sealants used on a hydraulic braking system.
Only brake fluid can be used for brake fluid. Brake fluid is a glycol-based liquid - it's closer to antifreeze than to oil, but don't use antifreeze in it either. Only brake fluid.
The brake system uses brake fluid and the trans uses trans fluid.