Same prob with 2000 Chevy garage says its the camshaft positioning sensor and no there are no codes when it does it they were suprized
Probably an alternator.
is this car an automatic? take car to an automatic transmission shop. sounds like the torque converter is about worn out
"getting the hang of it" means getting used to performing a specific task. If you're learning how to drive a stick shift, for example. At first you drive all jerky and the car stalls a lot. But as soon as you "get the hang of it", you're used to driving smoothly.
you need a new cam positioning sensor installed
Sounds like gas filter getting plugged with rust or something. Then after being down for while the rust falls off filter and starts until gas pressure plugs the filter again with dirt or rust or whatever.
Yamaha kodiak 400 starts then when u put it into gear and drive after a minite it reves up and stalls
Full pump is going out, or you have water in your tank. Or you need to replace the full filer(which you can find under the back seat).
(1995) ( Geo) ( tracker ),the wheel light comes on with the hubs locked in and the shifter in , but the 4 wheel drive does not appear to be locking in.
Drive it
If car is coughing and stalls out until you drive whats the problem.
some of these model cars(G M) had a switch that locks up the torque converter. When it goes bad it feels as though you are stopping a straight shift without pushing the clutch down.
There are several things that can cause your 2003 Geo Tracker four-wheel-drive not to work. The first thing you should check is the ground wire on the switch.