answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-08-08 16:12:13

check all the basics, and read up on diagnosis of more difficult items in a manual... fuel filter, plug wires, check engine light on? spark plugs etc etc etc etc etc etc etc...get it? Everyone should have a manual for their vehicle, and the library should have a professional shop manual available, for FREE, in the reference section(make copies of the correct sections) read up and fix it like a PRO! :) good luck-Dave

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


what is the valve settings surposed to be for a 87 s10 chevy pickup 2.8 ci


i needi have an 87 4 +cylender 2.5 Chevy s10 pickup and need the timing diagram in order to get it running. can you help?


4x6 in the dash and 6x9 in the rear


if it's the 4.3 you'd be lucky to get 12/18


i had an 87 Chevy s10 and it was doing that same exact thing at and idle it would push too much fuel and i changed the map sensor throttle positioning sensor and the whole works and then i decided to just change out the injectors and the fuel regulator. That fixed my problem hope i was some help


May be an auto resetting breaker in the main power dist. box under hood


restabbing distributor and setting time I'm replacing 4 cylinder motor in a 87 Chevy s10 how do I install distributor and get the truck in time


If the engine size is the same, probably


The spark plug gap for the 1987 Chevrolet S10 4-wheel drive pickup with the 2.8 liter TBI 6-cylinder engine is .045 (in thousandths of an inch). The spark plug tightening torque is 7-15 foot pound.


If that S10 has the 2.8L engine, the fuel filter should be found up in front of the engine close to the power steering pump.



Chevy didn't offer a 350 in an 86 Camaro, but if they did, it would theoretically work in an 87 Caprice.


On 87 and 88 s10 the speed sensor or vss is under the dash atached to a bracket it is a blue box about 3 inches square. It is not on the tail shaft or t-case on a 4x4


you can but depending on the transmission model you might have to buy a different bell housing for it



you have a choice of dropping the fuel tank or removing bolts holding the bed to frame and sliding bed back to expose the top of fuel tank. pump is inside of fuel tank


Need to know which engine you have.



i dont know i was wandering if someone could help me out with it i have a 87 gn motor and drivetrain in a 87 s10 think it will run


Is it possible to just eliminate the egr in my '87 Chevy S10 2.5 liter pickup? I find on cold days it runs very well but after it is warm it bucks and surges. Eliminating the EGR valve is a crime, punishable by a $10,000 fine. You need to have your EGR valve, Computer, and/or engine checked and repaired.


chevy products: camaros - 82+ corvettes - 68-96 el caminos - 64-87 s10,sonoma, blazer - 82+ g series vans - 71-96 Cadillac: Most 76-85


how to remove heater core 87 Chevy astro van. like to have diagram.


what is the squence and torque specs for an 2.8 v6


because it's an 87 celebrity I'd check the tranny. Could be low, or bad fluid. I've encountered similar when the radiator was too low on fluid also.


can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.