MOLTIVE COCKTAIL IT
Have you had your 4 oxygen sensors replaced? It turns out when they replaced my oxygen sensors, they were after market parts so the service engine light did not come and gave codes even though they were replaced.
On an N14 Cummins engine, the timing sensors are typically located on the front of the engine, near the timing cover. There are usually two sensors: the crankshaft position sensor, which monitors the position of the crankshaft, and the camshaft position sensor, which tracks the position of the camshaft. These sensors provide critical data for the engine's electronic control unit (ECU) to optimize fuel injection and ignition timing. Regular inspection of these sensors is important for proper engine performance.
I had all sensors replaced in my 03 Trailblazer and the check engine light stiil comes on. Why?
Of course not. They are screwed into the exhaust system and can be easily replaced.
There are dozens of reasons. But in most cars of this model some sensors just become old and have to be replaced. When sensors fail ECU sets off the check engine light.
No not a chance All mounts are WAY different not to mention the PCM and wiring and sensors
To fix an engine light code of 133 on a 1996 Ford Bronco with a 351 engine, the oxygen sensors need to be replaced. There are two oxygen sensors on this vehicle. One is on the driver's side and the other is on the passenger side of the exhaust or catalytic converter.
I just replaced the ECM and the code went away. I was not able to read any of the sensors on the engine with the scan tool. Once the ECM was replaced, everything was OK>
There are sensors all over the engine and transmission. There are also sensors at the wheel bearings and in the exhaust.There are sensors all over the engine and transmission. There are also sensors at the wheel bearings and in the exhaust.
It is probably your egr valve that needs replaced!
There are sensors all over the engine that can turn the check engine light on.There are sensors all over the engine that can turn the check engine light on.
The engine codes P0141 to P0161 on a 2004 Ford Freestar indicate issues with the oxygen sensors, specifically related to heating elements in the sensors. To fix this, first, inspect the wiring and connectors for damage or corrosion. If the wiring is intact, you may need to replace the faulty oxygen sensors in the bank indicated by the codes. After replacement, clear the codes and monitor for any reoccurrence.