Easy fix. Remove cluster by taking off trim ring and unscrewing the entire cluster unit. Should be three screws, two on either side and one at the top. Remove both wire harnesses at the top of the cluster and gently take it out of the dash. You can either purchase bulbs in the sockets from Honda, or find replacement bulbs at your local auto supply store. I think #74 should work. Put new bulbs in the sockets and twist them back into their respective holes. Place cluster back in dash and test before resrewing and putting back bezel.
The bulb is burnt out. You will have to remove the instrument cluster to gain access to the bulb for replacement.
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
There is no bulb, the clock is actually an LCD. The clock will have to be replaced.
Check your fuses first. There are many bulbs in your dash so it is unlikely they all blew.
my 1997 Toyota Tacoma has the dash/gauge light burnt out - i would like any help to locate bulb and replace i thank you
bulb #74 take the bezel off. unscrew the cluster, un clip the wiring harnesses, remove old bulb, insert new ones, put it back together and your done!!
take out light bulb in a dash
The dash bulb is #74 at your auto parts store like O'Reilly for about 1.50 ea or # 90981-11018 at Toyota parts 3.75 the #74 bulb with a plastic clip for the lighter etc is #74p good luck.. p.s. save & reuse the green colored boot on the bulbs.
Changing a light on the instrumental panel requires removing the whole dashboard on a 1992 Honda Civic. Loosen and remove all the dash mounting screws and pull of the dash. Remove the cluster from the display and pull off the old bulb. Install the new bulbs.
No you can't you must remove the dash.
it depends on the vehicle, on my motorcycle i have to remove the side and front plasics then remove the dash unit, then open the dash unit and replace the bulb, then put everything back.
The evaporator on the Ford Mustang is located between the dash and the firewall. Dash removal is required to remove the evaporator for replacement. The dealer replacement evaporator comes with the evaporator housing. The intake air assembly, blower motor, blower resistor, actuators, heater core, etc., have to be switched to the replacement housing. There is a photo on Honda Man's Bio page with the dash removed and the evaporator housing placed on the rear of the car.