You could have a dangerous vent back flow problem. Please call your utility company about an inspection (mine doesn't charge for this). How old is the water heater?
Sometimes it can take up to TWO MINUTES for the thermocouple to take effect ( proof of flame) If the flame does not stay on the thermocouple should be replaced by a qualified licensed plumber
its a pilot light, it burns the propane slowly so the propane doesnt just fill your house so that when you DO light it, it doesnt all explode. The small flame is the 'pilot light,' and it is there as a source of ignition for the propane gas entering the heater.
A pilot light flame should be about 90 percent blue. Flecks of orange are okay but if the flame is yellow, large, and flickering the pilot light may need an adjustment.
The water continues to run into and out of the water heater. There is just no flame to heat it up.
The flame of a candle is a source of light.
I need to replace the pilot light on a superserve calor gas fire as the flame is blue on the bottom and yellow at the top
The flame of a candle is a source of light.
Turn the knob on the top of the gas valve to "Pilot" and hold it down. Put your match or lighter near the pilot and it should light. Continue holding the knob down for about 30 seconds then release, and the pilot should stay lit. If it goes out then you may need to replace the thermocouple (the gold color rod that the pilot flame burns on) or have the pilot cleaned if it has a yellow flame.
when you light up the burner you should see that the Bunsen burners air hole is closed that is the safest flame
for dragons i saggest flame of the light light of flame fire 2020
sounds like you have a bad thermocouple. The thermocouple senses the pilot flame and produces voltage to tell main flame to light. Thermocouple can be bought at any hardware store.
If the pilot light is on, the heater should come on by itself. If the pilot light is off then it has to be lit. If it will not stay on, the thermocouple is bad.