Approximately 2 quarts of oil are needed to change the oil of a Polaris Outlaw 500 ATV. Slightly more oil is needed if the filter is changed.
There is no valves as it is a 2-stroke engine .
turn them in to lightly seat them and then turn them out 1and 1/2 turns
Start at 1 1/2 turns from seat and adjust for best idle 1/4 turn at a time
It would depend on which year, and fuel delivery system it has. If it has a 2-V, or 4-V carb, without a throttle position sensor, you would adjust the stop screw on the linkage at the end of the shaft, outside the throttle plate.(on the carb.)
Start at 1 1/2 turns from "seat" position and adjust each screw equally until you get the best and smoothest idle
very slow the 4 stroke cant even catch the 2 stroke with some mod work on the 2 stroke you can get 45-50 mph on a 90 check wrh racing and hetrick racing.
No it's not...You need to adjust your idle on the carb or it may need cleaned.
start with 2 1/2 turns out on high speed needle start with 1 1/2 on your low speed needle. adjust high as needed
other than idle speed, fuel mixture cannot be adjusted without removing carbeuretor, drilling our rivets in carb base and using special matco gm electronic carbeuretor adjusting tool. save yourself 2 hours of greif and frustration and probably failure, trash the carb and get yourself a remanufactured one
Loosen the 2 bolts on back axle.... then turn the center carrier it is what is called a concentric and will tighten chain. BUT don't tighten to much
The fuel pressure for a 2 bbl carb is 4-5 lbs.