It may be necessary to relax the handbrake-wire a little (the connection to the lever is just next to the catalytic converter under the car). On the front of the hub then, there is a small crosshead screw you need to remove. Then it remains to slowly jerk the hub off. It will not come off easily since the brake-shoes just barely pass the inner rim of the hub.
in fuel tank, after pull out the rear seat you will able to find the same.
Lift the vehicle on a car jack, remove the tire, remove the brake shoe/calipers, and remove the old brake pads. Put in the new brake pads, replace the brake shoe/calipers, replace the calipers, and lower the car.
To change the rear brakes on a 2000 Daewoo Lanos, start by safely lifting the vehicle and removing the rear wheels. Next, remove the brake caliper by unbolting it and carefully sliding it off the brake rotor. Replace the old brake pads with new ones, ensuring the caliper piston is pushed back into its housing. Finally, reassemble the caliper, reattach the wheel, and lower the vehicle before testing the brakes.
the brake has seized take the wheel off and beat the brake with a hammer
How do you remove rear brake drum from a 1993 Toyota pickup?
Remove the rear tire and wheel. Remove the brake spring from the brake assembly. Remove the brake pads. Reverse the process to install the new brake pads.
how do you remove rear brake drum on a suzuki 2004 xl7
Remove wheel, remove dust cap, should be a castle nut with a cotter key, remove key and castle nut. if memory serves, the drum should come off now.
How do you remove the rear brake rotor on a 2005 Dodge Ram 2500?
Remove rear wheels Loosen brake lines - but do not toally remove Loosen and remove 2 caliper mounting bolts remove brake line
To remove a coaster brake from a bicycle, you will need to first remove the rear wheel. Then, locate the coaster brake arm and disconnect it from the hub. Finally, remove any additional components attached to the brake system and reinstall the rear wheel.
after removing the two nuts from the rear light how do tou get it out of the rear panel