blue, thin belt, pink, take off belt, thick belt, blue, take off belt
dip ball in blue put | belt on dip in black take off | belt put - belt on dip in orange take off - belt put hat on dip in black take off hat put - belt on hat on dip in orange take both off put | belt on put hat on dip in blue take off both put - belt on and put the hat on to dip in orange take both off and there you go! :)
you take off the right passanger tire....... take off the serpentine belt and the power steering belt....... then u take off the harmonic balancer with a three claw gear puller....... then take off the cover behind it....... take off the top cover to the cam gears........ put a jack under the engine....... take off the motor mounts...... then take off the timing belt tensioner..... then take off the belt....... then take of off the water pump......... easy as that
Generally speaking to take a drive belt off: 1. Loosen the adjuster bolt and the mounting bolt, loosen the belt. 2. Slip the belt off of the pulley. There may be as many as four belts. If the belt you are taking off is behind other belts you will have to take them off first. If that is the case make note of the routing of each belt as you take them off so you will know where to put them back.
dip ball in blue put | belt on dip in black take off | belt put - belt on dip in orange take off - belt put hat on dip in black take off hat put - belt on hat on dip in orange take both off put | belt on put hat on dip in blue take off both put - belt on and put the hat on to dip in orange take both off and there you go! :)
take the back off and u will see where to put it.... Take off the front, remove the top retainers, lift the top up and then remove the remainder of the front panels, the blower assembly and then remove the drum....... rember where the screws go. Bqrry
It depends on the dryer but it sounds like the belt might be slipping or one of the drum rollers rubbing. Unplug dryer and see if you can access it workings from the bottom, if not remove the back dryer panel. You can try some 'Belt Dressing Spray - Found in automotive shops" on the dryer belt or some WD-40 on the drum rollers should it be one of them. If all else fails replace the dryer belt but that can be a bit of a job and it could be cheaper to just buy a new dryer.
You probably either have too much weight in the dryer or something is off with the belt. Try putting in smaller loads to reduce the weight or if that doesn't work have someone come out and take a look at it.
do you have to lower or lift engine to take bolt off belt tentioner 2002 pontiac sunfire.
You don't have your tongue in the right position. Put the belt on the drum and motor and pull the tensioner pully over to install it there.
first you take the belt from around it take apart a few clamps and pull it striaght out.By the way ai,m only 12.
Take the belt off, take the bolt off of the idler pulley, take the pulley off, put a new one on replace the bolt, and put the belt back on