period are measued in oscilloscope by using or calculating time division
An oscilloscope does not measure time. It is used to plot signals which are displayed as a change of voltage against (or with reference to) a change in time. To do this, the scope has to have something inside it to generate a "time tick" or otherwise provide a time reference. We usually find that a crystal oscillator is doing that job.
Cold cathode is a cathode, an electrode that emits electrons, which is not electrically heated by an element. Cold cathodes are used in gas discharge lamps such as neon lamps and discharge tubes.
A Cathode-ray tube is a vacuum that is used to get the air out. Cathode rays (electrons) cannot penetrate through any significant amount of air.
Thise electrode is the cathode.
More than likely, it is the DC Offset.
An oscilloscope is, essentially, a voltmeter -it measures current by measuring the voltage drop caused by that current across a standard resistance.
The meaning of the word oscilloscope is a device used for viewing oscillations, electrical current or voltage or, with a display on the screen of a cathode-ray tube.
an oscilloscope is used to measure sound waves
CRO; a cathode ray oscilloscope
Oscilloscope probes are used as part of an Oscilloscope. These are the pieces that connect to your circuit in which you would like to measure its sine waves.
Cathode Ray Oscilloscope - referring to the display component itself (cathode ray tube, as used to be used on televisions and computer monitors). Most oscilloscopes now use l.c.d. monitors; or can be synthesised on a PC with suitable software.
Wavelenght
CRO means cathode ray oscilloscope. The Cathode Ray tube is the display mechanism only. A CRO can be a digital or analog scope, with or without digital storage. A digital storage scope can use a CRO as the display mechanism, or it can use a LCD screen, or any other method. There was a type of Cathode Ray tube that used analog means to store the information on the screen, The storage takes place on the screen itself. They were pretty rare, and not seen at all today, as they didn't work very well. Perhaps that is what you are referring to?
When a signal of 10 mV at 75 MHz is to be measured then which of the following instrument can be used -
Cathode ray oscilloscope(CRO) is a device used to see the voltage across a particular element of your circuit and the wave form can also be seen on CRO. But you actually cannot measure the current using CRO as it is meant to give the voltage levels across any element in eletrically enegized circuit. however Digital Multimeter can do this job. But while using DMM to measure current one thing should be kept in mind that your circuit should be linear so that if you break the circuit to find current in series the current could not change in circuit.
Yes, some could be used for analog monochrome TV but lots of extra circuits would be needed. Picture would be green. Cost of oscilloscope would likely be several times a portable analog TV of similar size, even before adding extra circuits.
an oscilloscope