An oscilloscope does not measure time. It is used to plot signals which are displayed as a change of voltage against (or with reference to) a change in time. To do this, the scope has to have something inside it to generate a "time tick" or otherwise provide a time reference. We usually find that a crystal oscillator is doing that job.
period are measued in oscilloscope by using or calculating time division
An oscilloscope.
Why is the speed of the electron beam greater than the speed of light in cathode ray oscilloscope.
A: A sampling scope is not real time scope but rather a hi frequency rate of sampling which benefit the observer
If you must use an oscilloscope, then using Lissajous Figures will give you exact multiples of a given frequency. Naturally, you must have a known reference frequency at hand.These days a Frequency Counter will give adequate resolution.
period are measued in oscilloscope by using or calculating time division
A standard oscilloscope is designed to measure voltage, you need a current probe for your oscilloscope to measure current.
Oscilloscopes only measure voltage over time. Current cannot be measured with an Oscilloscope directly, but can be measured indirectly. Measure the voltage across a known load and calculate the current.
Oscilloscope probes are used as part of an Oscilloscope. These are the pieces that connect to your circuit in which you would like to measure its sine waves.
an oscilloscope is used to measure sound waves
yes
oscilloscope
Yes.
oscilloscope
You measure the peak to peak voltage and divide by 2.
change your resistance, its a little button, or if you are using an older oscilloscope, its a knob that will lower the sensitivity of the display. if it is something way higher than the oscilloscope can measure, you may have to run a resistor or transformer in the line.
change your resistance, its a little button, or if you are using an older oscilloscope, its a knob that will lower the sensitivity of the display. if it is something way higher than the oscilloscope can measure, you may have to run a resistor or transformer in the line.