If you would like to measure amps, there are two ways.
First, you can splice the wire you'd like to measure the amps of in half, and have the ammeter/multimeter test leads touch each of the wire's sides. Now the circuit will connect up again as if you never cut the cable, and you can measure amps.
The easier way is to get a clamp meter, which has a large loop that you can clip cables through and it will measure amps through induction, so you don't have to cut any cables.
An ammeter is always connected in series in the circuit.
Ammeter is coneccted in series with circuit but Voltmeter is connected in parallel.
The ammeter does affect the flow of current in a circuit, however, the resistance of the ammeter is so small in comparison to the circuit that the effect is negligible. It is connected in series.
Series connect it within the line of the circuit for which you are interested in measuring the current flow.More detailSince we measure the flow of current IN the circuit, the ammeter must be connected in series with the part of the circuit for which you are interested in measuring the current flow.One of the ammeter's terminals must be connected to a point of the incoming current flow and its second terminal must be connected to the point of on-going current flow. To do this, cut the relevant circuit wire and connect one terminal of the ammeter to each end of the cut.
To measure the current in the circuit an ammeter is used and it is connected in series
An ammeter is always connected in series and a vlotmeter in parallel
Because the ammeter connected in parallel will act as a short circuit.
The voltage remains the same across the circuit as it is a parallel connection. So, the current across the upper half of the circuit where the ammeter is connected is calculated as I = V/R = 12.04 (total voltage)/12 (Resistance R1) = 1 A. Hence, the ammeter will read 1 A.
The positive terminal of the battery would be connected to the positive terminal of the ammeter. The load would then be connected between the two negative terminals, positive side of the load being connected to the negative side of the ammeter.
Ammeters are connected in series with the load under test. This requires the load be disconnected from the source, and the ammeter placed in circuit. Voltmeters are connected in parallel with the load under test. This does not require any circuit changes. Sorry, but WikiAnswers does not support illustrations.
measures current in a circuit, must be series connected
ammeter