An exhaust system is basically a pipe. What the engine blows into the pipe at one end gets ejected into the atmosphere at the other. There's a muffler in there somewhere, which is basically a bucket with some baffles in it. The muffler will trap some of the sound which makes the engine run quieter. These days it's also a catalytic converter there. It's another bucket that looks like it's been filled with layers of cardboard, with all their small channels aligned lengthwise. As the exhaust fumes travel through these channels they react chemically with a liner in the catalytic converter and gets turned into something slightly less nasty.
car at back kundiyela
The opposite side of the exhaust pipe. If its dual exhaust, whatever side works best for manufacturing.
wire wheeling the valves is the best way but scotch bright works good to.
The strokes of a four stroke engine are intake, compression, power, and exhaust. The engine takes in the fuel, compresses it, uses it for power, and then the excess fuel comes out the exhaust.
Bathroom exhaust fans can be found on home improvement store websites. Check out homedepot.com and lowes.com and browse their selection of fans. They are sure to have one that works for your application.
A split air conditioner works by placing the evaporator indoors and the condenser outdoors. This keeps the exhaust heat from entering the building and interfering with cooling.
absolutely not, normal silicon melts at much too low of a temperature to put on exhaust. They make a special paste that comes in a tube that you put on exhaust holes and it hardens under the high temperatures. I have used it on my truck and it works really well.
You can do it if you remove the heat shield it works.
the bad buddy was lost ____________________ Or Alone in the frost. It works for a poem.
If there is not enough room for dual exh. because of transmission cross member. Do as I did . Take out cross member weld thick piece of metal about 9" long where exh. will be then cut a notch in cross member for exhaust. IT works wonderful!
The exhaust lifters will line up with the exhaust manifolds,Remove the valve cover if your working on a V8 and the valve that lines up with the exhaust port will be the exhaust valve,If it is a Chevy V8 they will be from standing in front of the car exhaust,intake,intake,exhaust,exhaust,intake,intake,exhaust.
exhaust