there not
there not
No, the primary consumer are herbivores whereas the secondary consumer is carnivores.
there not
Primary: 33% Secondary: 15% Tertiary: 52% Same as Philipenis'
If the number of turns in the primary is the same as the secondary, this would be an isolation transformer. Primary and secondary voltages should match (minus the inherent transformer losses), as should the current.
When the primary and secondary voltages are the same the transformer is being used for isolation. The secondary side will have galvanic isolation from the primary side. The purpose of the is to protect secondary load if a fault occurs on the primary side. The impedance of the transformer will limit the fault current on the secondary which should save equipment.
What is the question
No a Secondary Resource is totally different from a Primary Resource so it can't be the same. Primary Resource-The person who was there on that occasion Secondary Resource-The person who was not there on that occasion but knows a lot about it
The number of primary and secondary turns, or turns ratio, determine the secondary voltage given a particular primary voltage. So, for instance, if the primary voltage is 480/277 wye, and the desired secondary voltage is 208/120 wye, the turns ratio would be 2.3:1. If the primary and secondary voltages are the same, then yes, the number of turns on primary and secondary would be the same. But if you're not converting delta to wye or vice-versa, why would you have a transformer with the same input and output voltage, other than an isolation transformer?
It depends on the type of transformer.If it is a step up transformer the number of turns in secondary side is higher than primary.Stepdown means it will have fewer number of windings on the secondary side turns when compared with the primary side.An isolation transformer has the same number of windings on the primary as the secondary.The ratio of the windings is proportional to the increase or decrease in the secondary voltage. For example, twice the windings doubles the voltage and 1/2 the windings halves the secondary voltage. The isolation transformer is denoted as 1:1 and has the same voltage on the secondary as the primary.The ratio of secondary turns to primary turns is the same as the ratio of secondary voltage to primary voltage.e.g. if the secondary to primary turns ratio is 1/10, then the secondary voltage will be one tenth of the primary voltage.
Related colour's are when the secondary colour and another secondary colour have the same primary colour.
Related colour's are when the secondary colour and another secondary colour have the same primary colour.