It is a list of reinforcing for the works to be carried out, it lists location of the bar, bar mark, diameter of bar, number of pieces, length before bending, shape code and various lengths of the bent shape to show the maker where to bend It The schedule along with the steel drawing allows the workers to install the steel correctly.
we can calculate it with the help of formulas like number of bars=(length/ spacing)+1
In short this a previous estimation of quantity of reinforcement
By writing or typing it :P
The Bar bending schedule can tell anyone about the structure of the bar. It is a very vital document when figuring out if your bar is big enough or not. Or the calculations of spirally reinforced column.
if the bar length is 5o m , what will be the actual length including lap length
When we use a single stirrup to tide a beam or column at a time, we say it is two leg stirrup and thus if we use Double stirrup to tide a beam or column at a time, we say it is four leg stirrups. A single stirrup have two leg. _(Er. Aabid Iqbal)
There are multiple tube bending services to be found online on various websites. The most recommended websites are 'Tube-Bending-Service' and 'Barnshaws'.
MAXIMUM SHEAR force bending moment is zero shear force change inside is called bending moment
The length of your bar will help you estimate your bar bending schedule.
IS 2502
Bar bending schedule is a chart which describe the shape of bars, length of bars and total amount of steel is to be used in the specific design.
The Bar bending schedule can tell anyone about the structure of the bar. It is a very vital document when figuring out if your bar is big enough or not. Or the calculations of spirally reinforced column.
Half of the thickness of bar.
A bar bending schedule lets the contractor determine whether the pre-bent bars he received were measured and bent correctly. It costs money to wait until the bars are in place in the concrete forms only to find out they are incorrect.
1.59 kg/m Try this link for Bar bending schedule prepation softwares http://www.rgsrebar.com
if the bar length is 5o m , what will be the actual length including lap length
Tar steel of 16 mm diameter, you can find this notation in Bar Bending Schedule (BBS) and steel detailing..
cutting length depends upon the beam length. its including L in both sides
to facilitate checking and estimates can be prepared quickly by the help of BBS.
ROD is used for axial loading and torsion, but BAR can be used for axial, torsion as well as bending loads....