0
Harley Davidson decals can be removed from metal using metal wire or fishing line. Move the wire back and forth under the decal until it comes loose and can be pulled off.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What was the first Harley Davidson carburetor made of?
Metal/steel
How do you remove the seat on Harley Davidson fatboy?
Remove the rear seat screw. Then pull the rear seat to the rear and slightly up. It is held in by two metal tabs that slip under the front seat lip.
Where is the speed sensor on a 2003 harley Davidson fat boy?
speed sensor is located to the rear of the transmission chrome (retangular) cover. there are four bolts on the cover, if you are looking at the bike from the right side just behind the cover rear bolt is the speed sensor. loosen and remove Allen bolt with 3/16 Allen and rotate sensor just enough to pry out. it is in there snug. i just removed and cleaned my sensor. there were metal shaving. My symptoms were no speedometer , odometer, and turn signal not turning off after conmpleting turn.
Where do I get items to make my own decals?
The materials required to make your own decals can be purchased from websites like craftycomputerpaper.co.uk and are avalible in a variety of different pack sizes for a resonable price. These can be added to different surfaces such as plastic, soap, metal and wax.
How is metal removed from its ore?
matials
Can minor scratches be removed from stainless steel?
can minor scratches be removed from galvanized metal
What metal can be economically removed from sea water?
The most awaited metal that can be removed from the sea water is sodium and chlorine and as followed be other metals such as Mg, etc.
Metal squeal in primary drive harley on deceleration?
primary tensioner either needs adjustment or replacement
Bits of metal removed in the grinding process?
filings
What is the name of Metal removed in the process of grinding?
swarf
All of the air is removed from a sealed metal can After the air has been removed the can looks as if it were crushed Why?
It means that the air pressure that sealed the can - can not be removed
What do you do to purify a metal?
You have to get it hot enough where you get to the melting point of the metal. During this melting process the impurities will be removed from the metal and your end result is a purer metal.
