0
How can I access the coolant pipe for LeBaron GTC 1995 without taking off the intake manifold?
Wiki User
∙ 10y ago
the intake is the only way.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the Engine coolant temperature sensor located on Isuzu rodeo?
lol! On my 1997 Rodeo (v6, 3.2l) it is in the back -- the manifold must be removed to access it. lol! On my 1997 Rodeo (v6, 3.2l) it is in the back -- the manifold must be removed to access it.
Want to gain access to your 1989 Chrysler lebaron fuel pump?
You have to remove the tank to access.
Your 1994 Lincoln town car has a coolant leak and it seems like its coming from a little round cap under the engine next to the transmission what could it be?
There is a metal tube that runs under the intake manifold. It goes from the back of the water pump to the rear of the engine where it changes to a rubber heater hose. That metal tube is known to rust out and leak coolant. The intake manifold must be removed to gain access to the tube for replacement.
Where is the coolant temperature sensor on a 2009 Chevy aveo located?
the temp sensor is located on the right side of the engine under the intake manifold on the engine block. Easiest access is from underneath. Location on engine: no special tools is need it to remove it
Where is the fuel pump located on a 1992 Chrysler lebaron?
It is in the fuel tank, rear of tank needs lowered to access.
Where is starter location on Toyota sequoia?
Under the intake manifold Between the top intake manifold and the engine block. The top intake manifold must be removed to access the starter.
Where is starter located on 2004 Nissan Titan?
Under the intake manifold, u need to completely remove your intake manifold to Access it..
How do you get the head gasket off a 1996 buick regal?
The intake manifold, head, and exhaust manifold must be removed to gain access to the gasket.
Where is the starter located on a 1998 DeVille?
The starter is located under the intake manifold and requires removal of the intake manifold to access it. Good luck!
How do you change the knock sensor in a 2000 suburban?
The knock sensor (depending on engine) can reside either above the starter, or under the intake manifold. 5.7L and 7.4L knock sensors reside above the starter, passenger side of the engine. Exercise caution when removing them, as they're also blocking the water/coolant block drain on that side. 5.3L, 6.0L engines have two knock sensors under the intake manifold--so you'd need to remove the intake manifold to access them.
How do you chang a thermostat on a 2000 Nissan Maxima?
You need to first drain the coolant, to lessen the mess of spilt coolant. Next you have to unbolt the coolant neck at the block to access the thermostat. After replacing, you have to refill/bleed the coolant system.
Where is 02 sensor located on 1993 Toyota Paseo?
it's in the down pipe coming from your exhaust manifold. you will have to remove the heat shield from the exhaust manifold to access it
