The EGR valve is located on the intake manifold. If you're having trouble finding it, just look at your new one and then find it's match on the truck. It should come off with a few bolts (usually 12mm). Be sure to scrape the old gasket off and replace it as well, as leaving this on could cause leaks. After you've done this, just bolt the new one on and you're done. It's also good to buy a Haynes mannual for your specific vehicle. This book is less than $20 at most auto stores and gives you step by step instructions on things like this, with pictures.
how do replace a power steering hose on a Chevy c-1500 pickup truck
What year,what motor?? it is a 2002 Chevy avalanche 1500
That year model did not have a modulator valve on the transmission.
That year truck does not have a modulator valve on the transmission. it has a electronic transmission in it.
You replace the EGR valve.
The PVC valve is located on the top of the engine. It is on the drivers side of the engine close to the back.
you don't. buy a new wheel hub
No!! Its a 1/2 ton pickup
That transmission is COMPUTER CONTROLLED and does NOT have a modulator valve. If you are having transmission problems then you need to have the transmission scanned with an OBDII engine scanner to see what is going on.
The EGR valve on a 1994 Chevy 1500 is located on the top of the engine. If the valve becomes stopped, the engine could idle rough or stall.
It sure will.
Yes it is.
around 1500 to 3000
Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
The payload for the 1985 Chevy S10 pickup is between 1000 and 1500 pounds depending on the exact model. The S10 is the smallest of the Chevrolet pickup series.
there is not one
i need rear break digram for my Chevy 1500 k pick up where can i find it.
Where is the vent vale solenoid on a 2006 Chevy silverado 1500 4.8 L
The Chevy SBC 5.7L 350cid V8 was the standard