answersLogoWhite

0

By visual inspection. That's not a very common event though, unless the bolts aren't tourqed properly...

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the Starter on a 92 Ford Crown Victoria LX V8 and how can you tell if it's bad?

under the engine on the passenger side by the manifold have fun I think it is a three bolt. The Third bolt is a dosey


What is the torque specs for 96 Chevy beretta z26 3.1?

Lower intake manifold bolt 115 in/lb. Upper intake manifold bolt 18 ft/.


Can a supercharger from a 3.8 bolt up to a 3.1?

If it is the family of engine blocks, manifold will bolt on, yes.


What is bolt torque for lower intake manifold for 97 buick lesabre?

The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.


Where is the MAP sensor on a duratec 1.8 Ford Mondeo engine?

It's in the front of the intake manifold secured in using one torx bolt. Look down the front of the car between the radiator and the manifold and you will see the sensor pushed into the manifold and secured with a torx bolt.


1996 Chevrolet c1500 pickup truck bolt torque specifications for 5.0L intake manifold?

1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold


What is a 82 cutlass bolt pattern?

Bolt pattern for what? Nearly everything that has more than one bolt has a bolt pattern. Are you looking for the wheel bolt pattern? Or the torque pattern for say, the intake manifold bolts?


Can you use a a turbo exhaust manifold off of a 4g63 on a 420a?

It will bolt on, but to answer your question, no.


You have replaced your exhaust system with a new one up to the exhaust manifold the exhaust manifold looks fine but you still get loud engine noise inside the car?

have you checked to see if there is any broken bolt on the manifold, or worped manifold, burnt manifold gasket


What are torque specs for head gasket and intake manifold for 1999 Pontiac sunfire?

The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.


What size bolts go into your intake manifold because you have two that are broken and oil is leaking out?

You can't just drop new bolts in the holes where the broken bolts came out of. The manifold has to be removed and the broken bolt ends removed with an EZ-Out or at a machine shop. While the manifold is off, you can take one of the bolts to an auto parts store for match-up and buy the bolts you need.


What is Chevy 454 exhaust manifold bolt torque install sequence?

40 lbs