answersLogoWhite

0

What else can I help you with?

Related Questions

How do I replace the head gasket on a 1995 suzuki sidekick?

Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.


How do you replace the whole head gasket set on 1994 sidekick 4wd?

Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.


What are the torque specs and torque sequence for a 1992 Nissan Maxima intake manifold?

what are the torque specs and sequence for a 1992 Nissan maxima manifold


What is the torque spec for the exhaust manifold on a 95 Honda Odyssey?

The 1995 Honda Odyssey exhaust manifold bolt torque specification is 45 pounds. The exhaust manifold bolts should be torqued in 15 pound intervals.


What is the torque for an exhaust manifold on a 2001 Kia Sportage?

exhaust manifold to head nuts are 31 ft. lbs.


What is the torque spec for Isuzu 2.6 exhaust manifold?

The first torque spec for Isuzu 2.6 exhaust manifold in 58 ft lb. It has a second torque spec which is 72 ft lb.


How can coolant leak from the front and rear exhaust manifold bolts after a overhaul?

Incorrect torque pounds, or incorrect sequence of torque,improper gasket installation, foreign matter not allow gasket to properly seal or warped intake manifold or warped block


1979 Gmc 350 exhaust bolt torque?

Exhaust manifold torque is 25 lb/ft with anti-seize lube.


What is the Intake manifold torque sequence 455?

35 ft pounds


What is the torque spec for Ford 300 6 exhaust manifold?

Torque for the 300 6 intake and exhaust manifolds is 28 to 32 foot pounds


What is the torque settings for d16y5?

The torque settings for the exhaust manifold lower heater shield bolts for?æa d16y5 is 96 in - lbs. The oil pan drain plug torque settings is 29 and exhaust pipe to manifold nuts is 25.?æ


How do you install an exhaust manifold on a mid-90's Ford Aspire?

Follow the manual (Haynes, Chilton, Ford Factory). After the old manifold is off, clean the mating surfaces. Install a new gasket (no cement). Bolt on the new manifold. Tighten the bolts and nuts to the torque specs in the manual following the procedure in the manual. Bolt it to the exhaust pipe (new gasket also).