Drunk drivers are the cause of most accidental dealths.
Forget about him and find someone else.
If, by 'reverse polarity', you mean the accidental reversal of the line and neutral conductors at the socket outlet or receptacle, then the answer is no.
Drunk drivers cause most accidental deaths.
No. That is mechanical, not electric.
Most motorcycles do not have a reverse gear. Exceptions are some trikes and sidecar combinations. Examples: Motorcycle: Honda Goldwing - electric reverse Sidecar: Ural - mechanical reverse Three wheel: Bombardier Spyder - mechanical reverse Some Harley trike conversions offer an option to add mechanical reverse. Some engines have been known to run in reverse unintentionally. This can happen with single cylinder or two cylinder engines (usually two stroke) with misadjusted ignition timing. When that happens, the bike will indeed go backwards.
An electrical motor generator in reverse means that it can turn the electrical energy to mechanical and kinetic energy.
Low fluid, shifter malfunction, electrical malfunction, internal mechanical malfunction.
Because it is usually a mechanical cable that is connected to a front axle or the transmission. Newer cars relay this information electronically and will show the actual speed when in reverse.
actually...reverse is down next to second instead of up next to first, after the downward pressing of the entire shift rod into the floor, move the shifter to the left toward your knee and back toward the front corner of your seat. there is a safety mechanism made of plastic in the bus transaxle which prevents accidental shifting from first into reverse when shifting into second. however, very few of these transaxles still have this safety mechanism in tact, often resulting in the accidental grinding of reverse while attempting the shift into second. hope this helps. :) the previous post reflects the proper shifting into reverse on water-cooled vw models, not air-cooled such as the bus or beetle.
No, both are reverse to each other , turbine produces mechanical work by the expansion or by the conversion of fluid kinetic energy,while ,pump is used to utilise mechanical power into fluid energy.
This helps to prevent the gearbox from being stripped and other major mechanical failures.