0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is break down region of zener diode?
Zener breakdown is the phenomena wherein the Zener diode experiences reverse breakdown at a much lower voltage than a normal diode, which may breakdown in excess of 100 volts, depending on the type. This is useful because the Zener will hold the same voltage after breakdown, regardless of the input voltage, making them excellent for voltage controlled switches and references.
Are diode forward and zener voltages the same?
A: Both diodes have the same curve in the forward direction however if the zener voltage is reverse it will breakdown at a particular voltage and remain conducting at the voltage. A regular diode will not do that the to voltage will fold back after breakdown to any voltage
What will a Zener diode do at breakdown voltage?
A Zener Diode will continue to show its breakdown characteristics until it gets fried...for example a 5 volt zener will get fried at a breakdown voltage of about 6 volts..this happens because of the large amount of current flowing through the small diode which unfortunately the diode cannot handle.
Why does voltage remain constant in the reverse breakdown region in a zener diode?
This space is for answering "http://wiki.answers.com/Q/Why_does_voltage_remain_constant_in_the_reverse_breakdown_region_in_a_zener_diode" Why does voltage remain constant in the reverse breakdown region in a zener diode?
Why breakdown voltage increase in reverse biased p-n junction diode?
when the p-n junction is heavily doped p-n junction diode has very sharp breakdown voltage.
How the breakdown voltage of particular diode can be controlled?
By Varying the impurity concentration
How the breakdown voltage of a particular diode can be controlled?
By Varying the impurity concentration
What is the forward breakdown voltage for in4007 diode?
there is no forward breakdown voltage for any diode
What is break down region of zener diode?
Zener breakdown is the phenomena wherein the Zener diode experiences reverse breakdown at a much lower voltage than a normal diode, which may breakdown in excess of 100 volts, depending on the type. This is useful because the Zener will hold the same voltage after breakdown, regardless of the input voltage, making them excellent for voltage controlled switches and references.
What is the breakdown voltage of 1N4007 diode?
The reverse breakdown voltage of the 1N4007 diode is 1000 volts.
Does the material of the diode depends on break down voltage?
A Germanium diode has a much lower breakdown voltage than a silicone diode.
Why breakdown occurs in diode?
Normally too higher voltage burns the diode.
Why does a rectifier diode is not operated in breakdown voltage?
The breakdown voltage of a diode is the minimum voltage at which it conducts in both directions. If you have a 100-volt rectifier diode (1N4002) and you wire it into a 110v circuit, it will flow current in both directions and you'll get no rectification.
What is breakdown voltage of diode?
The critical value of the voltage, at which the breakdown of a P-N junction diode occurs is called the breakdown voltage.The breakdown voltage depends on the width of the depletion region, which, in turn, depends on the doping level. The junction offers almost zero resistance at the breakdown point.
Does zener diode works after breakdown voltage?
Yes. The intended use of a zener diode is to be reverse biased at the breakdown voltage. In this mode, the zener has high slope in the current to voltage curve, making it a good choice for voltage regulation.
What happens to zener current after the breakdown voltage is reached?
After breakdown voltage is reached in a zener diode the current increases drastically.
Can zener diode used as rectifier?
Yes **************************************** Yes they can but there are pitfalls. A normal diode will have a high reverse breakdown voltage. A zener has a relatively low breakdown voltage (its "zener"voltage). If a zener diode is used as a rectifier it must have a zener voltage at least twice the peak of the applied a.c.
