Want this question answered?
(Inlet SO2-Exit SO2)X100 ----------------------------- Inlet-(1.5xinletXExit)/100
The typical flue gas temp at the inlet to the air heater is about 650-750 DegF range.
73 pence and the finest silk button in all the land!
Yes, as long as the exit point of the hose is lower than the input (suction) point. Once it is, you have to "bleed" the hose by sucking fuel through it; the gravity of the fuel falling out of the hose at the outlet will perpetuate the suction at the inlet.
No a 230 volt appliance should not be pluuged into a 110 volt socket (And vice versa) you need to buy a converter that can be plugged into the 110 volt outlet then the appliance can be plugged into the converter.
Inlet line will be bigger then the outlet line. on the contrary on my motorcycle fuel pump, the inlet and outlet are the same size!
Delta T (oC) =Inlet Temperature (oC) -outlet temperature (oC)
valve clearance hot - inlet mm 0,3 and outlet 0,56
The inlet side is the low side - this will have the larger hose. On a Thermal Expansion Valve system, this hose will run from the evaporator outlet to the compressor inlet. On a Fixed Orifice Tube system, this hose will run from the accumulator outlet to the compressor inlet. The outlet side is the high side, and the hose will run from the compressor outlet to the condenser inlet.
A tee is a plumbing fixture with one inlet and two outlets, or two inlets and one outlet. A cross is a fixture with one inlet and three outlets, or three inlets and one outlet.
Upper and lower radiator, inlet and outlet heater core, bypass,Upper and lower radiator, inlet and outlet heater core, bypass,
Generally a "pond" is taught of as a still body of water smaller than a lake. "still" implies no flow movement and would mean that there is no inlet or outlet. However, the term "pond" is sometimes extended as in "Mill Pond" which would have both an inlet and an outlet.
Inlet or outlet
outlet ports are smaller to reduce the exhaust losses
For efficiency's sake, the outlet had best be a lot cooler.
Compressor outlet to metering device inlet.
it is the pressure difference between inlet and outlet of pump.