Best advice I can give is 'Buy one' you have not even specified what rpm you require.
To determine the size of the hydraulic motor needed to be equal to a 3 hp electric motor, you would need to calculate the hydraulic motor's power output in horsepower. Hydraulic motors are generally less efficient than electric motors, so you may need a larger hydraulic motor to match the power output of a 3 hp electric motor. Consult the manufacturer's specifications and consider factors such as efficiency and operating conditions.
A single phase 10 HP motor will draw aproximately 50 amps. A three phase 10 HP motor will draw aproximately 28 amps.
No, you cannot use a starter rated for a 5 hp motor with a 7.5 hp motor. The starter needs to be matched to the motor's horsepower rating to ensure proper protection and operation. Using an undersized starter can lead to overheating and premature failure of the motor. It is recommended to use a starter specifically designed for a 7.5 hp motor.
To calculate the kilowatts per hour used by a 1.5 hp electric motor, you first convert horsepower to kilowatts: 1.5 hp is approximately 1.12 kW (1 hp ≈ 0.746 kW). If the motor runs continuously for one hour, it would consume about 1.12 kWh. However, the actual consumption may vary based on the motor's efficiency and load conditions.
HP/.00134= Watts Then Watts divided by Volts = AMPS For expample. a .75 HP electric motor running on 220VAC uses 2.544 amps .75 / .00134 = 559.7015 Watts then 559.7015 / 220 = 2.544
You will need to install a phase converter or change the motor to single phase. You can find a licensed electrician at www.contraxtor.com
20 HP Three phase 360 volt what is the amps
Horsepower is horsepower, so a 16 hp electric motor could, on the surface, replace a 16 hp gas motor. Things to consider, however, include RPM and torque. Gas engines are inefficient, to replace a 16 hp gas engine it would take only a 8 hp electric. standard closest size would be a 10 hp. I have done this several times on air compressors and hydraulic pumps.
200 hp requires about 149kW
The maximum single phase HP motor listed in the CEC is 10 HP. At 115 volts 100 amps and 230 volts 50 amps.
you need the current of motor or the KW/HP rating
Most likely a defective phase winding in the motor or even a missing phase in your power input.